Specifications

2. Installation and Setup

NOTE:

Before installation, please inspect the unit. Be sure that nothing inside the package is

damaged. Please keep the original package in a safe place for future use.

NOTE:

There are two different types of online UPS: standard and long-run models. Please refer to the

following model table.

Model Type Model Type

1000 1000L

2000 2000L

3000

Standard

3000L

Long-run

2-1. Rear View

1000(L) TOWER 2000(L) TOWER 3000(L) TOWER

1. Programmable outlets: connect to non-critical

loads.

2. Output receptacles: connect to mission-

critical loads.

3. AC input

4. Input circuit breaker

5. Network/Fax/Modem surge protection

6. Emergency power off function connector

(EPO)

7. USB communication port

8. RS-232 communication port

9. SNMP intelligent slot

10. External battery connection (only available

for L model)

11. Output terminal

12. Output circuit breaker

2-2. Setup the UPS

Step 1: UPS input connection

Plug the UPS into a two-pole, three-wire, grounded receptacle only. Avoid using extension cords.

Use the input power cord from your server or protected equipment. Use the supplied output cable

to connect between UPS and your server.