User manual
Service Menu Parameters
88
Figure 79 iCOM-DO events setup screen, page 2 of 3
Status—Shows whether an output is in a normally closed or normally open state.
Output #—Shows which output is tied to a particular alarm. The default values are set to be the
same output as the Liebert ENV-DO card, the predecessor to the Liebert iCOM-DO.
ID—Displays the number of the Liebert iCOM-DO. Currently only one Liebert iCOM-DO card is
supported.
Figure 80 iCOM-DO events setup screen, page 3 of 3
iCOM-DO Events Setup (pg 2 of 3)
to change parameter
to confirm
to select parameter
for next/previous unit
then
UNIT 01
S731
S732
S733
S734
S735
S736
S737
S738
S739
S740
S741
PASSWORD (Actual Level 3) ????
Event Description ID Output # Status
Cooling Status No 9 0
Heating Status No 9 0
Humidifying Status No 10 0
Dehumidifying Status No 11 0
High Temperature No 12 0
High Humidity No 13 0
Low Temperature No 14 1
Low Humidity No 15 1
iCOM-DO Events Setup (pg 3 of 3)
to change parameter
to confirm
to select parameter
for next/previous unit
then
UNIT 01
S742
S743
S744
S745
S746
S747
S748
S749
S750
S751
S752
PASSWORD (Actual Level 3) ????
Event Description ID Output # Status
High Head Pressure C 1 No 9 0
High Head Pressure C 2 No 9 0
Loss of Airflow No 10 0
Change Filters No 11 0
Water Alarm No 12 0
Condensing Pump Alarm No 13 0
Glycool Status No 14 0
Unit On No 15 1