User manual

Liebert iCOM Display Components and Functions
7Liebert
®
iCOM
®
The User menu contains the most frequently used features, settings and status information. The
Service menu contains settings and features used to set up unit communications and for unit
maintenance. The Advanced menu contains settings used to set up the unit at the factory. Do not
attempt to make any changes in the Advanced menu without consulting the factory first.
2.3.2 Accessing Submenus
While the display is at unit status screen, press either the Enter or down arrow key to display the
User menu. To access the Service menu, press the right arrow key. Pressing the right arrow key again
will display the Advanced menu. For navigating to the sub-menus from each main menu, press Enter
key and then the appropriate arrow key. Pressing the Enter key again to access the menu items.
Figure 8 Menu tree—Small display, stand-alone or networked
NOTE
Menu settings may be viewed without a password, but changing settings requires a password.
The password for the User menu is 1490. The password for Service menu is 5010. For details
on entering a password, see Entering a Password on page 10
Status Menu
Unit 1 View
User Menu
Password
Setpoints
Event Log
Graphics
Set Alarms
Sensor Data
Active Alarms
Display Setup
Total Run Hours
Sleep Mode
Service Info
Condenser Timer
Service Menu
Unit 1
Password
Setpoints
Unit Diary
Standby Settings/Lead-Lag
Maintenance/Wellness Settings
Diagnostics / Service Mode
Set Alarms
iCOM-DO
Sensor Calibration/Setup
Economizer
System/Network Setup
Options Setup
Service Contact Info
Remote Sensors
Advanced Menu
Password
Factory Settings
Expert Settings
Compressor Info
MBV Settings
Change Passwords
Runtime Monitoring
Control Override
Global Condenser
Condenser Control