Installation manual

Network Settings
16
5.3 Management Protocol
The Management Protocol Menu allows you to enable or disable
SNMP and configure management protocols. Consult your network
administrator for these settings.
Terminal Emulation (Serial or TCP/IP Connection) / Telnet
To change any parameter:
1. Choose IP Network Settings from the Main Menu, then Management Protocol.
2. Select an option to change, then use the following guide to make changes.
Web Interface: Velocity Server Option (Liebert NXL, Liebert XDP with Liebert iCOM &
Liebert CRV)
To access Velocity Server settings through the Web interface for the Liebert NXL, Liebert XDP with
Liebert iCOM or Liebert CRV:
• Click on the Configure tab, then Management Protocol in the left panel and finally Edit in
the right panel.
•Check the Velocity Server enabled box to activate. After making changes, click Save.
Table 11 Management protocol ranges
Parameter Description & Telnet Menus
SNMP Agent
Enable or disable SNMP for remote
management.
SNMP
Communications
The SNMP Communications Menu shown at
right allows you to set up access privileges
and configure the Web card to send traps.
For details about these options, refer to 5.3.1 -
SNMP Communications Menu. Also see the
additional references for more information
listed in Table 12 in that section.
Velocity Server
Access
(Liebert NXL,
Liebert XDP with
Liebert iCOM &
Liebert CRV)
Enable or disable Velocity Server Access for Liebert NXL, Liebert XDP with Liebert iCOM or
Liebert CRV.
Also see the next section, Web Interface:
Velocity Server Option (Liebert NXL,
Liebert XDP with Liebert iCOM &
Liebert CRV).
Note: Option 3 applies to the
Liebert NXL, Liebert XDP with
Liebert iCOM & Liebert CRV.
Management Protocol Menu
-------------------------
1: SNMP Agent enabled
2: SNMP Communications
3: Velocity Server
Access enabled
<ESC>: Cancel menu level
Please select a key ?>
Enable SNMP Agent? [y/n] ?>
SNMP Communications Menu
-------------------------
1: Authentication Traps 'no'
2: RFC-1628 (UPS) MIB 'enabled'
3: - Traps 'enabled'
4: Liebert Global Products MIB 'enabled'
5: - Condition Traps 'enabled'
6: - System Notify Trap 'enabled'
7: Heartbeat Trap Interval’’
8: Display/Modify Communities
9: Display/Modify Trap Communities
A: Support Information
<ESC>: Cancel menu level
Please select a key ?> 1
Enable Velocity Server Access? [y/n] ?>
Click on
Edit to
make
changes
Velocity Server
check box
Management
Protocol
Configure
tab