Installation manual

Network Settings
18
5.3.1 SNMP Communications Menu
Use the SNMP Communications Menu to enable
authentication traps and view or change communities and
trap communities, events and parameters.
Refer to Table 12 for details on each menu option, as well as
the following sections:
• Section 5.3.2 - Display/Modify Communities
• Section 5.3.3 - Display/Modify Trap Communities
• Section 9.2 - Events and Parameters
(for details on viewing Support Information)
Table 12 SNMP communications menu
Parameter Description & Telnet Menus
Authentication Traps
Enables authentication traps to receive security alerts when the Web card detects
a request with an invalid community string.
RFC-1628 (UPS) MIB
Enables the RFC-1628 (UPS specific information) MIB on the Web card for
querying of information in that MIB. This can be enabled or disabled independently
of the Liebert Global Products MIB.
Traps
This option enables the RFC-1628 traps to be sent when an alarm event occurs on
the device. The parent option must be enabled for this to also be enabled.
Liebert Global Products MIB
Enables the Liebert Global Products MIB (Enterprise Specific) for querying of
information in that MIB. This option can be enabled or disabled independently of
the RFC-1628 MIB.
Condition Traps
Enables event condition traps to be sent per the LGP MIB. The parent option must
be enabled for this to also be enabled.
System Notify Trap
Enables system traps to be sent per the LGP MIB. The parent option must be also
enabled for this to be enabled.
Heartbeat Trap Interval
Specifies how often a heartbeat trap will be sent to show that the device is online
and functioning normally.
Display/Modify
Communities
View devices that have permission to access the Web card, identified by IP
address or hostname, read/write permission and community string. Up to 20
devices may be configured for access.
See 5.3.2 - Display/Modify Communities.
Display/Modify
Trap Communities
View devices that are configured to receive notifications from the Web card,
identified by IP address or hostname, trap listen port and community string. Up to
20 devices may be configured to receive traps.
See 5.3.3 - Display/Modify Trap Communities.
Support Information
View a list of all supported events and parameters for the Liebert equipment
through any interface. Depending on the Liebert IntelliSlot Web card, the list might
include SNMP and Modbus.
See 9.2 - Events and Parameters.
SNMP Communications Menu
-------------------------
1: Authentication Traps 'no'
2: RFC-1628 (UPS) MIB 'enabled'
3: - Traps 'enabled'
4: Liebert Global Products MIB 'enabled'
5: - Condition Traps 'enabled'
6: - System Notify Trap 'enabled'
7: Heartbeat Trap Interval’’
8: Display/Modify Communities
9: Display/Modify Trap Communities
A: Support Information
<ESC>: Cancel menu level
Please select a key ?> 1