Installation manual

Factory Settings

7.0 FACTORY SETTINGS

The Factory Settings menu allows you to restore factory default settings and offers other options that

may vary by the Liebert unit where the card is installed. Refer to the following sections for details:

• 7.1 - Reset to Factory Defaults

• 7.2 - Advanced Communication Settings

• 7.3 - Agent Event Log - Liebert NXL, Liebert XDP with Liebert iCOM & Liebert CRV

• 7.4 - Support Information - Liebert NXL, Liebert XDP with Liebert iCOM &

Liebert CRV

• 7.5 - Realtime Information - Liebert NXL, Liebert XDP with Liebert iCOM &

Liebert CRV

• 7.6 - Task Stack Usage - Liebert NXL, Liebert XDP with Liebert iCOM & Liebert CRV

7.1 Reset to Factory Defaults

Factory default values may be restored for all configuration settings. This step:

• Replaces all user-defined settings described in this manual (see 3.0 - Configuration Overview

through 6.0 - Messaging)

• Restores DHCP service, the factory default, replacing a static IP address or hostname, if config-

ured during installation (see 2.0 - Installation)

Terminal Emulation (Serial or TCP/IP Connection) / Telnet

To restore the factory default settings:

1. Choose Factory Settings from the Main Menu, then choose Reset

to Factory Defaults.

2. Enter y (yes) at the prompt to confirm your choice. To cancel, enter n (no).

3. A message appears until the process is complete.

Web Interface

To restore the factory default settings through the Web interface:

• Click on the Configure tab, then Factory Defaults in the left panel and finally Reset to Fac-

tory Defaults in the right panel.

Reset to factory Defaults? [y/n] ?>

Resetting card to factory defaults...

Factory Settings Menu

----------------------

1: Reset to Factory Defaults

2: Agent Card Information

<ESC>: Cancel menu level

Please select a key ?>

Factory

Defaults

Configure tab

Reset

to Factory

Defaults