Installation manual

Connect to the Card - Terminal Emulation, Telnet or Web Interface

A.2.3 Open the Telnet Interface

To connect to the card using Telnet:

1. Open a Telnet connection on a computer with an Ethernet connection to the Liebert unit.

To do this:

• Open a command prompt window—click the Start button, then

Run.

• Enter cmd and click OK.

• In the command prompt window that opens, enter telnet fol-

lowed by a space and the IP address of the Web card—for exam-

ple:

telnet 192.168.0.125

2. When the message at right appears in the command prompt window,

press the Enter key.

3. Enter the Administrator username and password (both are case-

sensitive):

a. Login (username—default is Liebert)

b. Password (default is Liebert)

A.2.4 Open the Web Interface

To connect to the card using the Web interface:

1. Open a Web browser such as Internet Explorer.

2. Enter the IP address of the Web card in the address bar—e.g., 192.168.0.125.

3. Click on a tab at the top of the window.

C:>telnet 192.168.0.125

RTCS v2.96.00 Telnet server

Service Port Manager Active

<Esc> Ends Session

Password: ********

Configure and

Support Tabs