User's Manual

Service Menu Parameters
Liebert
®
iCOM
®
164
Figure 158 Sensor calibration/setup screen, page 11 of 12
S6C5 Supply Sensor Aggregation—Five additional supply air sensors (2T sensors) may be
connected for control purposes. This parameter enables and disables the additional supply air sensors
for control purposes.
S6C6 Supply NTC—Allows including or excluding the sensor reading from the Maximum or Average
Aggregation Method.
S6C7 Sensor A (CAN ID 17)—Allows the include or exclude the sensor reading from the Maximum
or Average Aggregation Method.
S6C8 Sensor B (CAN ID 18)—Allows including or excluding the sensor reading from the Maximum
or Average Aggregation Method.
S6C9 Sensor C (CAN ID 19)—Allows including or excluding the sensor reading from the Maximum
or Average Aggregation Method.
S6D1 Sensor D (CAN ID 30)—Allows including or excluding the sensor reading from the Maximum
or Average Aggregation Method.
S6D2 Sensor E (CAN ID 31)—Allows including or excluding the sensor reading from the Maximum
or Average Aggregation Method.
S6D3 Aggregation Method—Allows including or excluding the sensor reading from the Maximum
or Average Aggregation Method.
S6D4 Current Aggregation Supply Temp—Displays the maximum or average temperature based
on Aggregation Method programming in degrees Celsius or degrees Fahrenheit.