Owner's Manual

ManualsBrandsEmerson ManualsFan AccessoryEmerson LK150

READ AND SAVE THESE INSTRUCTIONS

Ceiling Fan

Light Fixture

Owner’s Manual

Net Weight: 2.6 Lbs.

Includes: Three 60-Watt

Candelabra Bulbs and Fitter

Model Numbers:

LK150

LK151

Safety Instructions

WARNING: To avoid fire, shock, and serious personal injury, follow all instructions carefully.

1.Read your Owner's Manual carefully before installing the light fixture. Retain Owner's Manual for

future reference.

2.Be careful of the fan and blades when cleaning, painting, or working near the fan. Before installing

or servicing the light fixture or ceiling fan, switch power off at service panel and lock service panel

disconnecting means to prevent power from being switched on accidentally. When the service

disconnecting means cannot be locked, securely fasten a warning device, such as a tag, to the

service panel.

3.Do not exceed the wattage indicated on fixture.

ADDITIONAL SAFETY INSTRUCTIONS FOR INSTALLATION

1.To avoid possible electrical shock be sure electricity is turned off at the main fuse or circuit breaker

box before wiring.

2.Make certain no bare wires are exposed outside the wire connectors.

3.All wiring must conform to national and local electrical codes.

4.Follow the recommended instructions for the proper method of wiring your new light fixture. If you

feel you do not have enough electrical wiring knowledge or experience, have your light fixture

installed by a licensed electrician. Any electrical work not described in this manual should be

performed by a licensed electrician.

WARNING: To reduce the risk of possible fire and electrical shock, install only on Emerson CF772

Series Ceiling Fans in indoor locations.

Part No. F40BP74420001 Form No. BP7442-1

Revision: 130402 ETL Model Nos.: LK150 and LK151

Summary of content (4 pages)

PAGE 1
READ AND SAVE THESE INSTRUCTIONS Ceiling Fan Light Fixture Owner’s Manual Net Weight: 2.6 Lbs. Model Numbers: LK150 LK151 Includes: Three 60-Watt Candelabra Bulbs and Fitter Safety Instructions WARNING: To avoid fire, shock, and serious personal injury, follow all instructions carefully. 1.Read your Owner's Manual carefully before installing the light fixture. Retain Owner's Manual for future reference. 2.Be careful of the fan and blades when cleaning, painting, or working near the fan.
PAGE 2
7. Insert the black and white wires through the lockwasher and hex nut (supplied), firmly tighten the hex nut to secure the light kit fitter to the switch cup. Connect the white wire from the switch cup to the white wire of the light fitter (Figure 2). Connect the blue wire from the switch cup to the black wire of the light fitter. Use listed wire connectors (previously removed in Step 5) to make connections (Figures 2 and 3). 8. Carefully tuck all wires and splices into the switch cup. (Figure 2.) 9.
PAGE 3
5. Connect the white wire from the ceiling fan to the white wire of the light fitter. Connect the blue wire from the ceiling fan to the black wire of the light fitter. Use listed wire connectors (previously removed in Step 3) to make connections. (Figures 5 and 6.) NOTE: The FN200 finial pack (supplied) comes with three options: no holes, one hole and two holes for pull chain options. 12. 13.
PAGE 4
10. Install three 60-watt candelabra base bulbs (supplied) into the light sockets. 11. Connect the wood pendant (supplied) to the switch pull chain by sliding the wood pendant (small hole first) onto the pull chain. Attach the chain coupling to the end of the chain and allow the wood pendant to fall down over the coupling. 12. Connect the wood pendant (supplied) to the light kit chain by sliding the wood pendant (small hole first) onto the pull chain.