Technical data

Controls, LEDs, and Connectors
MVME4100 Single Board Computer Installation and Use (6806800H18D)
61
3.3.3 Connectors
This section describes the pin assignments and signals for the connectors on the MVME4100.
The next table lists the standard connectors on the MVME4100 base board. Refer to Figure 3-1
on page 58 for connector locations. Pin assignments for the connectors are in the following
sections. Some connectors use standard pin assignments in compliance with the VMEbus, IEEE,
PCI, and ANSI/VITA specifications. Links to these specifications are located at Appendix B,
Related Specifications, on page 132.
Table 3-2 Base Board Connectors
Reference Designator Function Notes
J6 XMC Expansion 8X PCI-E to XMCSpan
J4A TSEC 1, 10/100/1000 Ethernet RJ-45
GENET 1 on front
J4B TSEC 2, 10/100/1000 Ethernet RJ-45
GENET2 on front
J11, J12, J13, J14
J21, J22, J23
PMC1
PMC2
Implementing all recommended and
optional VITA32 signals except
RESETOUT#
J1 Port 0. Serial Port 1 Micro DB-9 console serial port on front
P1 VME five-row P1
P2 VME five-row P2 on SBC and RTM TSEC3 signals assigned to E1-1 thru E1-4
TSEC4 signals assigned to E2-1 thru E2-4
Serial ports 2-5
J2 USB Single channel upright USB connector.
USB1 on front
USB2 on RTM
P4 Processor COP header Planar header for processor COP
emulation
P5 Boundary Scan header Planar header for boundary scan and
PLD/flash programming