Application Guide

Installation Instructions Section 5876
Spec. No. 582140000 (Models 802
NLDB, 802NLEB and 802NL-B) Issue AT, April 26, 2013
Chapter 3. Installing Distribution Devices and MCA/LMS Circuit Cards Page 3-5
This document is property of Emerson Network Power, Energy Systems, North America, Inc. and contains confidential and proprietary information owned by Emerson Network Power, Energy
Systems, North America, Inc. Any copying, use, or disclosure of it without the written permission of Emerson Network Power, Energy Systems, North America, Inc. is strictly prohibited.
Figure 3-2
Installing Load Lug Adapter Plates into Power/Distribution Bays
* Includes Load Lug Adapter Plate,
plus 1/4" and 3/8" Mtg. Hardware.
Bus #1
Distribution Device
Mounting Location
Position 1 (left),
Position 24 (right)
Bus #2
Distribution Device
Mounting Location
Position 25 (left),
Position 48 (right)
Front View
Load Lug Adapter
Plate P/N 513701,
Kit P/N 520892*
Load Lug Adapter
Plate P/N 514765,
Kit P/N 520894*
Load Lug Adapter
Plate P/N 513702,
Kit P/N 520893*
Load Lug Adapter
Plate P/N 513700,
Kit P/N 520891*
to Distribution:
Bus #1
Position #12
to Distribution:
Bus #2
Position #25
to Distribution:
Bus #2
Position #36
to Distribution:
Bus #1
Position #1
to Distribution:
Bus #1
Position #13
to Distribution:
Bus #1
Position #24
to Distribution:
Bus #2
Position #37
to Distribution:
Bus #2
Position #48
1 12 13 24
25 36 37 48
Load Lug and/or
Load Lug Adapter Plate
Mounting Locations
REFER TO DISTRIBUTION DEVICES ILLUSTRATIONS
FOR PROPER LOAD LUG ADAPTER SELECTION
NOTE THAT BULLET NOSE
-TYPE DEVICE MOUNTING
ASSEMBLIES DO NOT REQUIRE LOAD LUG ADAPTER PLATES
Torque to
84 in-lbs
Hardware Build-Up
Load Lug Adapter Mounting Studs
Load Lug Adapter Plate
Flat Washer
Lock Washer
1/4-20 Nut