BP7355 PERISTYLE CF100 9/19/07 11:26 AM Page 1 READ AND SAVE THESE INSTRUCTIONS PERISTYLE™ Ceiling Fan Owner's Manual Model Numbers CF100AP00 Antique Pewter with Natural Cherry/Mahogany Blades CF100DBK00 Distressed Black with Distressed Black/Natural Cherry Blades CF100GES00 Golden Espresso with Teak/Golden Espresso Blades Net Weight: Part No. F40BP73550001 30.0 Lbs. Form No. BP7355-1 U.L. Model No.
BP7355 PERISTYLE CF100 9/19/07 11:26 AM ! Page 2 WARNING WARNING: To avoid fire, shock, and serious personal injury, follow these instructions. Safety Instructions 1. Read your owner’s manual carefully and keep it for future reference. 2. Before servicing or cleaning unit, switch power off at service panel and lock service panel disconnecting means to prevent power from being switched on accidentally.
BP7355 PERISTYLE CF100 9/19/07 11:26 AM Page 3 This Manual Is Designed to Make it as Easy as Possible for You to Assemble, Install, Operate and Maintain Your Ceiling Fan 1. Open styrofoam unit containing fan. Tools Needed for Assembly Remove top half of styrofoam unit. Remove parts and check to see that you have received the following parts: NOTE: If you are uncertain of part description, refer to exploded view illustration.
BP7355 PERISTYLE CF100 9/19/07 11:26 AM 2. Remove the fan motor and housing assembly from the protective plastic bag. Place the fan assembly into the upper foam pad with the top of the motor facing up. The upper foam pad serves as a holder for the fan during the first stages of assembly. General Your Emerson ceiling fan comes equipped with a remote control transmitter and a remote control receiver.
BP7355 PERISTYLE CF100 9/19/07 11:26 AM 2. Slide the four switch levers on the code switch to your choice of ON (up) or down positions. Use a ball-point pen or small screwdriver and slide the levers firmly up or down. 3. In the receiver (Figure 1), slide the four switch levers to the same positions as set in the transmitter. Make sure the levers on both switches are in the same positions, otherwise the fan will not operate. 4.
BP7355 PERISTYLE CF100 ! 9/19/07 11:26 AM Page 6 5. Reinstall the hanger ball (Figure 5) on the downrod as follows. Route the three 80” motor leads through the hanger ball and slide the hanger ball over the downrod. Position the pin through the two holes in the downrod and align the hanger ball so the pin is captured in the groove in the top of the hanger ball. Pull the hanger ball up tight against the pin and securely tighten the setscrew in the hanger ball. A loose setscrew could create fan wobble.
BP7355 PERISTYLE CF100 9/19/07 11:26 AM Page 7 11. Engage the connector of the switch housing/light fitter assembly with the motor connector (Figure 8). The two connectors are color-coded and must be mated correctly (color-to-color) before they can be engaged. Make sure the connectors close properly. 10-24 x 9mm TRUSS HEAD SCREW (3) FIBER WASHER (3) FAN BLADE BLADE FLANGE MOTOR CONNECTOR SWITCH HOUSING SWITCH CONNECTOR HOUSING PLATE Figure 6 8.
BP7355 PERISTYLE CF100 9/19/07 11:26 AM 14. You have now completed the assembly of your new ceiling fan. You can now proceed with hanging and wiring your fan. ! WARNING Hanger bracket must seat firmly against outlet box. If the outlet box is recessed, remove wall board until bracket contacts box. If bracket and/or outlet box are not securely attached, the fan could wobble or fall.
/19/07 11:26 AM How to Wire Your Ceiling Fan is visible at the wire connectors, except for the ground wire. 2. Refer to Figure 13 and 14 and connect the receiver wires to the supply wires and the fan motor wires as follows: a. Securely connect the green grounding wires from the hanger ball and the hanger bracket to the supply grounding conductor (this may be a bare wire or a wire with green insulation). b. Securely connect the supply white (neutral) wire to the receiver white (AC IN N) wire. c.
BP7355 PERISTYLE CF100 TO 120VOLT SUPPLY 9/19/07 11:26 AM Page 10 STANDARD ON-OFF WALL SWITCH OR OPTIONAL SW113 WALL CONTROL BLACK BLACK (HOT) BLACK WHITE WHITE WHITE GROUND BLACK TWO-CONDUCTOR CABLE (WITH GROUND) BLUE WHITE BLACK BLUE WHITE GREEN WIRE (GROUND) FROM HANGER BALL AND HANGER BRACKET Figure 14 HANGER BALL 3. Push the wires and connectors up into the outlet box while inserting the receiver fully into the hanger bracket. Position the antenna wire on top of the receiver. 4.
BP7355 PERISTYLE CF100 9/19/07 11:26 AM Page 11 NOTE: Slightly loosen the four screws securing the lower ring brackets to the switch housing assembly. Operating Your Ceiling Fan 9. Securely grasp one of the lower ring posts and raise the lower ring up to one of the lower ring brackets. Secure the lower ring post to the lower ring bracket using a bracket mounting screw (Figure 16). Grasp the opposite post and secure the post to the opposite bracket using a bracket mounting screw.
BP7355 PERISTYLE CF100 9/19/07 11:26 AM Page 12 Maintenance Accessories IMPORTANT CARE INSTRUCTIONS for your Ceiling Fan 1. Downrod Extension Kits (see store or catalog). Periodic cleaning of your new ceiling fan is the only maintenance that is needed. 2. Ceiling Fan Controls (see store or catalog). When cleaning, use only a soft brush or lint free cloth to avoid scratching the finish.
BP7355 PERISTYLE CF100 9/19/07 11:26 AM Page 13 WARNING: FOR YOUR OWN SAFETY TURN OFF POWER AT FUSE BOX ! OR CIRCUIT BREAKER BEFORE TROUBLE SHOOTING YOUR FAN. Trouble Shooting TROUBLE 1. Fan will not start. PROBABLE CAUSE 1. Fuse or circuit breaker blown. 2. Loose power line connections to the fan, or loose wire connections in the switch housing. 3. Wall switch is off. 4. Defective battery in remote control transmitter. 5.
BP7355 PERISTYLE CF100 9/19/07 11:26 AM Page 14 Repair Parts 1 2 3 5 4 14 7 6 8 15 9 10 11 18 13 16 12 17 26 FAN/OFF HI FOR/REV MED LIGHT DIMMER LOW 23 ® 22 19 20 21 24 25 14 U.L. Model No.
BP7355 PERISTYLE CF100 9/19/07 11:26 AM Page 15 Repair Parts Listing Part Numbers Key No. Description Model No. CF100AP00 Model No. CF100DBK00 Model No.
BP7355 PERISTYLE CF100 9/19/07 11:26 AM Page 16 LIMITED WARRANTY What The Warranty Covers: This warranty covers the motor and the other components and accessories of your Emerson ceiling fan against all defects in workmanship and materials. You must be the original purchaser or user of the product to be covered. What The Period Of Coverage Is: As it applies to the motor, this warranty will last for the lifetime of your ceiling fan.
