Owner's Manual

20. Insert the connected ends of the wires
up through the open side of the
hanger bracket and into the outlet box
as shown in Figure 20.
21. Screw two 1-1/4” threaded studs
(supplied with the ceiling fan) into the
tapped holes in the hanger bracket
(Figure 20).
OUTLET BOX
RECEIVER
CEILING
COVER
HANGER
BRACKET
1-1/4"
THREADED
STUDS (2)
Figure 20
22. Slide the receiver up and over the
hanger bracket. Press the receiver
against the ceiling, holding it in place
while installing the ceiling cover in
accordance with the instructions in
the Ceiling Fan Owner’s Manual.
23. Install the optional Emerson Light
Fixture in accordance with the
instructions in the Light Fixture
Owner’s Manual. Use the screws
removed in Step 1.
NOTE: To prevent damage to the
receiver, turn “off” the electricity at the
wall switch before installing or
removing light bulbs on the ceiling fan
or light fixture.
Trouble Shooting
Fan/Light Fails to Operate
• Check that the speed switch on the
fan is set to HIGH (
....
) speed.
• Check that the light switch is on.
• Check that the battery is good
(red indicator light should light when
any button is pressed).
• Check that the receiver is wired
properly.
• Check that code switches in the
remote control and receiver are set in
the same position.
Short Range
• If the remote control operates the fan
when close to it, but does not operate
it at a distance of 40 feet, try placing
the antenna wire outside of the ceiling
cover.
14
BP7416 RCK55 Receiver 10/30/09 11:20 AM Page 14