Owner's Manual

General
Your Emerson Ceiling Fan/Light SR600
Remote Control consists of hand-held
transmitter and a receiver which is
mounted under the fan ceiling cover. The
remote control is designed to separately
control your ceiling fan speed and light
intensity.
The remote control transmitter is powered
by two AAA alkaline batteries (not
included). To prevent possible damage if
the batteries should leak, be sure to
remove the batteries when the control is
not to be used for an extended period of
time.
Code switches in the transmitter and
receiver may be set in 32 different
positions. If your fan and light go on and
off without using your control, you may be
getting interference from other remote
units such as garage door openers, car
alarms or security systems. To remedy this
situations, simply change the combination
code in your transmitter and receiver.
Preset Memory Feature
Your Emerson receiver is equipped with a
preset memory feature. If the AC supply to
the receiver is powered through a wall
switch, when the switch is turned OFF, the
control will remember the light intensity
and fan speed. When the switch is turned
back ON the light and fan will resume
operation as they were prior to the switch
being turned OFF.
Installation of Battery
1. Remove the battery cover by pressing
firmly below the arrow and sliding the
cover off the control (Figure 1).
2. Install two AAA alkaline batteries and
reinstall the battery cover.
3
General
Your Emerson Ceiling Fanl may be used
with a SR600 or SR650 Remote Control, a
SW605 Wall Control, and a RCK55 6-
speed Receiver. The remote control or
wall control is designed to control your
ceiling fan speed, airflow direction, and
light intensity.
NOTE: The RCK55 Receiver and
Module for Use Only with Emerson
Ceiling Fan Models: CF4800, CF4500,
CF2400,CF2000, CF3900, CF3600, &
CF1.
Unpackaging
The carton with the RCK55 Receiver also
contains a reversing module, seven wire
connectors, four pull chain switch plugs,
and two rectangular switch plugs.
The carton with the SR650 Remote
Control contains a storage bracket with
two mounting screws.
The carton with the SW605 Wall Control
contains three switch covers; ivory, white
and almond color.
IMPORTANT
This Owner’s Manual is divided into three
sections. The first section, SR600/SR650
REMOTE CONTROL PROCEDURES,
describes how to install the two AAA
alkaline batteries in the SR600 remote
control transmitter and the two CR2032
Lithium batteries in the SR650 remote
control transmitter, and how to set the
operating frequency of the transmitter
and receiver. The second section
describes how to install the SW605 Wall
Control. These instructions must be
performed prior to installation of the
ceiling fan as described in the third
section, CEILING FAN PROCEDURES.
SR600 REMOTE
CONTROL PROCEDURES
SECTION ONE:
BP7416 RCK55 Receiver 10/30/09 11:20 AM Page 3