Owner's Manual

4. If airflow is desired in the opposite
direction, press the ( ) button on the
wall control. The fan must be operating
at any speed for the reverse button to
function. The blades will turn in the
opposite direction and reverse the
airflow.
LIGHT
BUTTON
HIGH TO LOW
SPEED BUTTONS
FAN
DIRECTION
POWER
INDICATOR
LIGHT
FAN
BUTTON
ON/OFF SWITCH
O = OFF / — = ON
Figure 10
9
CEILING FAN
PROCEDURES
Installation to Operate the
Ceiling Fan, Downlight
and Uplight
IMPORTANT
It is important that you also follow the
installation instructions contained in
the Owner’s Manual supplied with your
Ceiling Fan. Pay particular attention to
the Safety Instructions and WARNING
notes.
1. Remove and retain the screws
securing the housing cover to the
switch housing (Figure 11).
2. All Ceiling Fan Models. Disconnect
the motor connector from the wiring
harness connector (Figure 11).
Remove the knurled nut securing the
speed control switch
to the switch
housing.
HOUSING COVER
(TYPICAL)
SCREW (TYPICAL)
SCREW (2)
KNURLED
NUT
SPEED
CONTROL
SWITCH
PULL
CHAIN PLUG
REVERSING SWITCH
SWITCH HOUSING
CAPACITOR
MOTOR
CONNECTOR
WIRING
HARNESS
CONNECTOR
Figure 11
3. For Ceiling Fan Models CF2400,
CF4500 and CF4800 Only. Remove
the wire connector joining the three
blue wires. (Figure 12). Separate the
blue wire coming from the ceiling fan
and cap this wire using a wire
connector (supplied). On Models
CF4500 and CF4800 only, cut the
yellow wire coming from the uplight
switch; cap the end of this wire coming
from the center of the motor using a
wire connector. On Model CF2400 only
,
remove the wire connector joining the
two yellow wires; cap the yellow wire
coming from the motor using a wire
connector (orange wire on older
models). Remove the knurled nut
securing the uplight switch to the switch
housing and remove the uplight switch.
NOTE: Keep the uplight switch if you
think you may like to return to manual
control in the future.
SECTION THREE:
BP7416 RCK55 Receiver 10/30/09 11:20 AM Page 9