IntelliSlot® Relay Card User Manual
Contents 1.0 Introduction 3 1.1 Inspecting Shipment on Receipt. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 2.0 Installation 4 2.1 Required Parts & Tools. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 2.2 Installation Instructions. . . .
1.0 Introduction The IntelliSlot relay card (IS-RELAY) provides contact closure for remote monitoring of alarm conditions in your SolaHD UPS. The IntelliSlot relay card is easy to install and integrates with other relay contact monitoring systems. This advanced power management device is designed to function in units with a IntelliSlot port, such as: • S4KC Series • S5K Series Please visit our Web site at www.solahd.com for the current list of supported products.
2.0 Installation 2.1 Required Parts & Tools NOTE: Make sure you have the following parts and tools before you begin the installation. • IntelliSlot relay card (provided) • #2 (medium) Phillips or small flathead screwdriver 2.2 Installation Instructions 1. Turning off the UPS prior to installation is suggested, although not required. 2. Locate the IntelliSlot port. (See examples in Figure 1.) Refer to the UPS user manual for port location and orientation. 3.
3.0 PIN Configuration The IntelliSolt relay card has two terminals blocks, TB1 (green, numbered 1–9) and TB2 (black, numbered 10–18), as shown in Figure 2. 1 10 TB1 green TB2 black 9 18 Figure 2: PIN location & numbering Please refer to the UPS User manual for the UPS terminal block configuration. The PIN functions in Table 1 apply only to the SolaHD units listed in Section “1.0 Introduction”.
4.0 Jumper Setup The IntelliSlot relay card has five jumpers, P3 through P7, as shown in Figure 2. Each jumper connects two PINs. Front of card Jumper P6 Jumper P5 Jumper P4 Jumper P3 Jumper P7 Figure 3: Jumper location & numbering By default, all five jumpers have shunts installed. The two PINs are shunted together to provide the functions shown in Table 2, allowing relay commons to be tied together.
5.0 Technical Support 5.1 Contact Information To contact SolaHD technical support, please use one of the following methods: • Phone: 1.800.377.4384 (US) or 1.847.268.6651 (International) • E-mail: solahd.technicalservices@emerson.com • Web site: www.solahd.
SolaHD • 1.800. 377.4384 (US) • 1.847.268.6651 (International) • www.solahd.