BP7417 SR600 SR650 SW605 12/15/09 8:29 PM Page 1 READ AND SAVE THESE INSTRUCTIONS Ceiling Fan/Light Remote Control & Wall Control Owner's Manual For Use With RCK55, RC188 or RC212 Receivers Remote Control Model Number: Remote Control Model Number: SR600 SR650 Wall Control with Switch Covers Model Number: SW605 Part No. F40BP74170000 Form No.
BP7417 SR600 SR650 SW605 12/15/09 ! 8:29 PM Page 2 WARNING Safety Instructions WARNING: To avoid fire, shock, and serious personal injury, follow all instructions carefully. 1. Read your Owner's Manual carefully before installing the Remote Control or Wall Control. Retain Owner's Manual for future reference. 2. Before servicing or cleaning the ceiling fan, switch power off at service panel and lock service panel to prevent power from being switched on accidentally.
BP7417 SR600 SR650 SW605 12/15/09 8:29 PM Page 3 SR600 REMOTE CONTROL PROCEDURES General Your Emerson Ceiling Fan/Light Control may be used with a SR600 or SR650 Remote Control or a SW605 Wall Control. The remote control or wall control is designed to control your ceiling fan speed, airflow direction, and light intensity. General Your Emerson Ceiling Fan/Light SR600 Remote Control consists of hand-held transmitter and a receiver which is mounted under the fan ceiling cover.
BP7417 SR600 SR650 SW605 12/15/09 8:29 PM Installation of Battery Setting Operating Frequency of SR600 Remote Control 1. Remove the battery cover by pressing firmly below the arrow and sliding the cover off the control (Figure 1). Your remote control has code switches which must be set in one of 32 possible code combinations. The five levers (numbered 1, 2, 3, 4, and 5) on the switches are factory-set in the ON (up) position. Change the switch settings as follows: 2.
BP7417 SR600 SR650 SW605 12/15/09 8:29 PM SR650 REMOTE CONTROL PROCEDURES Page 5 Installation of Battery 1. Remove the battery cover by pressing firmly below the arrow and sliding the cover off the control (Figure 3). General Your Emerson Ceiling Fan/Light SR650 Remote Control consists of hand-held transmitter with wall mount and a receiver which is mounted under the fan ceiling cover. The remote control is designed to separately control your ceiling fan speed and light intensity.
BP7417 SR600 SR650 SW605 12/15/09 8:29 PM Page 6 Setting Operating Frequency of SR650 Remote Control Setting Operating Frequency of SW605 Wall Control Your remote control has code switches which must be set in one of 32 possible code combinations. The five levers (numbered 1, 2, 3, 4, and 5) on the switches are factory-set in the ON (up) position. Change the switch settings as follows: 1. Slide the five switch levers in the remote control to your choice of ON (up) or down positions.
12/15/09 8:29 PM Page 7 Installation of Wall Control ! SINGLE-POLE INSTALLATION Do not connect any neutral (white) wire to this control. Incorrect wiring will damage this control. (Figure 6) HOT SW605 FAN/LIGHT WALL CONTROL BLK HI 4. Connect one black wire of wall control to the “hot” wire. Securely connect wires with wire connectors supplied (Figure 7). 5. Connect one black wire of wall switch to the “load” (black) wire in wall box. Securely connect wires with wire connector supplied. 6.
:29 PM 3-WAY INSTALLATION 3-WAY WIRlNG DIAGRAM: NEW CONSTRUCTION (On fan controlled by two different wall controls) (See Figures 8 and 9.) ! ! WARNING WARNING Check to see that all connections are tight and that no bare wires are visible at the wire connectors. Turning off wall switch is not sufficient. To avoid possible electrical shock, be sure electricity is turned off at the main fuse or circuit breaker box before wiring.
BP7417 SR600 SR650 SW605 12/15/09 8:29 PM STANDARD WIRING FOR EXISTING 3-WAY CONTROLS HOT Operation of Your Wall Control (Figure 10) EXISTING WALL CONTROL BLK IMPORTANT BLACK Fan installation must be completed, including the installation of the fan blades, before testing the remote control. TRAVELER WIRES Your wall control has full control of your fan and light.
BP7417 SR600 SR650 SW605 12/15/09 8:29 PM Page 10 Trouble Shooting Fan/Light Fails to Operate Short Range • Check that the speed switch on the fan is set to HIGH (....) speed. • Check that the light switch is on. • Check that the battery is good (red indicator light should light when any button is pressed). • Check that the receiver is wired properly. • Check that code switches in the remote control and receiver are set in the same position.
BP7417 SR600 SR650 SW605 12/15/09 8:29 PM Page 11 LIMITED WARRANTY What The Warranty Covers: All products covered by this Owner’s Manual are warranted against all defects in workmanship and materials. You must be the original purchaser or user of the product to be covered.
BP7417 SR600 SR650 SW605 12/15/09 8:29 PM Page 12 Air Comfort Products DIVISION OF EMERSON ELECTRIC CO. 8100 W. Florissant • St. Louis, MO 63136 Part No. F40BP74170000 Printed in China 12/09 Form No.