Owner's Manual

HOT
BLK
TRAVELER WIRES
BLACK
LOAD
EXISTING
WALL CONTROL
FAN/LIGHT
WALL CONTROL
BLK
BLACK
LOAD
TRAVELER WIRES
HOT BLK
EMERSON
®
EMERSON
®
BLK
BLK
HI
MED
LOW
FAN OFF
LIGHT
ONOFF
HI
MED
LOW
FAN OFF
LIGHT
ONOFF
3-WAY WIRING DIAGRAM: RETROFIT
Figure 9
Operation of Your Wall
Control
(Figure 10)
Your wall control has full control of your
fan and light.
NOTE: Prior to operation of the fan and
light from the wall control, set the fan
speed to HIGH (
....
) and turn the light
ON ( ).
1. To set the desired fan speed, press the
( ) button to decrease the speed and
the ( ) to increase the speed. The LED
display will light up to indicate the new
speed selected.
2. To turn the light on and off, press and
release the LIGHT ( ) button. To set
the light intensity, press and hold the
LIGHT ( ) button. The light will turn on
at the light intensity previously selected.
3. Your wall control comes complete with
your choice of three wall cover plates;
ivory, white and light almond.
Fan installation must be completed,
including the installation of the fan
blades, before testing the remote control.
IMPORTANT
STANDARD WIRING FOR EXISTING
3-WAY CONTROLS
4. If airflow is desired in the opposite
direction, press the ( ) button on the
wall control. The fan must be operating
at any speed for the reverse button to
function. The blades will turn in the
opposite direction and reverse the
airflow.
LIGHT
BUTTON
HIGH TO LOW
SPEED BUTTONS
FAN
DIRECTION
POWER
INDICATOR
LIGHT
FAN
BUTTON
ON/OFF SWITCH
O = OFF / — = ON
Figure 10
9
BP7417 SR600 SR650 SW605 12/15/09 8:29 PM Page 9