User Guide

Battery Replacement:
Remove these 4 screws,
gently lift the pickguard’
remove and replace the battery.
Step Eight:
This completes the installation. Plug the battery clip onto the battery.
We suggest you plug in the instrument, tap lightly on the pickups with
a small screwdriver to make sure the pickups are working correctly.
When the battery needs to be replaced (about 6 months to 1 year)
refer to the diagram at the right.
Retro Active S/S/S COMBINATION SYSTEM INSTRUCTIONS Page 4
Step Six:
1) Plug the Output Cable from the PC Board (GND/SIG) to the Volume Control.
2) Plug the Output cable from the Output Jack onto the Volume control as shown.
3) Plug the green wire onto the Ring terminal of the Switch PC Board.
Step Seven:
Plug the Battery clip cable onto the BAT- (BLACK) and the BAT+ (RED)
terminals of the PC Board.
OUTPUT CABLE TO THE VOLUME CONTROL
GREEN WIRE TO THE RING
TERMINAL PIN OF THE PC BOARD
FROM
OUTPUT JACK
BATTERY CLIP TO BAT- AND BAT+
TERMINALS ON THE PC BOARD
- 9V +