User Guide

ManualsBrandsEMG ManualsElectric Guitar PartsEMG GTV Glenn Tipton Vengean Guitar Pickup Set, Red

.390

(10)

(6)

(8)

.235

.310

INSTALLATION INFORMATION

EMG MODELS: EMG-GTV SET

GLEN TIPTON VENGEANCE

Warranty

All EMG Pickups and accessories are warranted for a period of two years. This warranty does not cover failure due to improper installation, abuse or damage. If

upon examination the pickup is determined to be defective, a replacement will be made. Warranty replacement products are covered by this same warranty. This

warranty covers only those pickups and accessories sold by authorized EMG Dealers. This warranty is not transferable.

PO BOX 4394

SANTA ROSA, CA

95402 USA

P (707) 525-9941

F (707) 575-7046

EMGPICKUPS.COM

0230-0309rA

*Note: C/S (Ceramic/Steel)

SPECIFICATIONS: MODEL:

GTV

Logo Color Black

Magnet Type * C/S

Resonant Frequency (KHz) 1.44

Output Voltage (String) 3.00

Output Voltage (Strum) 4.50

Output Noise (60 Hz) -100

Output Impedance (Kohm) 10

Current @9V (Microamps) (System) 160

Battery Life (Hours) 1500

Maximum Supply (Volts DC) 27

PICKUP CABLE 15” (38cm)

OUTPUT CABLE 6” (15cm)

4 CONNECT CABLES 5.5” (14cm)

BATTERY CABLE 7” (18cm)

B245

PICKUP CABLE 15” (38cm)

2.75

1.50

3.09

3/48 MOUNTING HOLES

.900

.725

(69.8)

(38.1)

(22.8)

(18.4)

(78.5)

- 9V +

STEREO OUTPUT

JACK

ADJUSTMENT

SCREWS & SPRINGS

(2 PAIR)

1 VOLUME CONTROL (25K)

1 TONE CONTROL (25K)

Included with THE GTV SET:

Summary of content (4 pages)

PAGE 1
2.75 (69.8) 0230-0309rA 1.50 (38.1) PO BOX 4394 SANTA ROSA, CA 95402 USA 3.09 (78.5) 3/48 MOUNTING HOLES P (707) 525-9941 F (707) 575-7046 EMGPICKUPS.COM .900 (22.8) .725 (18.
PAGE 2
Installation Instructions: EMG Models: EMG-GTV General Notes: Every attempt has been made to make this a solderless installation. There are some instances where this is not possible; 1) If your instrument uses the long panel output jack and you had passive pickups you will need a new stereo output jack, the Switchcraft 152B is recommended. Soldering to the new jack will be required, see diagram #6.
PAGE 3
Diagram #3 2 Pickups Toggle Style Select Switch Master Volume & Master Tone - 9V + BATTERY NEG (-) GROUND NECK P/U MASTER VOLUME RED OUTPUT B122rH R RED S VOLUME BRIDGE P/U RED MASTER TONE BRIDGE PICKUP B124rH T TONE NECK PICKUP OUTPUT CABLE Diagram #4 2 Pickups Toggle Style Switch Volume each Pickup (Volumes are independent) Master Tone - 9V + BATTERY NEG (-) GROUND NECK P/U B124rH RED OUTPUT MASTER TONE R S RED BRIDGE P/U TONE RED OUTPUT CABLE NK VOLUME B122rH NECK PICKUP
PAGE 4
- 9V + BATTERY NEG (-) R GROUND S NECK P/U T OUTPUT CABLE OUTPUT BRIDGE P/U B122rH VOLUME TONE RED Diagram #5 2 Pickups 2 Volume (either volume will act as a master) 2 Tone BRIDGE PICKUP Toggle Style Switch B124rH RED NECK PICKUP NK VOLUME NK TONE RED B122rH B124rH VOLUME TONE BR TONE BR VOLUME Soldering to the 152B Panel Jack: If the instrument has a Battery Holder: If your instrument has a long Panel Jack like the one below you will have to solder the output cable as shown.