Instruction manual

24
English
CODE POSSIBLE CAUSE POSSIBLE SOLUTION
35
Paint spray on internal motor parts Contact an E MGLO factory service center or an E MGLO
authorized service center. Do not operate the compressor in
the paint spray area. See flammable vapor warning.
36
Fuse blown, circuit breaker tripped 1. Check fuse box for blown fuse and replace as necessary.
Reset circuit breaker. Do not use a fuse or circuit breaker
with higher rating than that specified for your particular
branch circuit.
2. Check for proper fuse. You should use a time delay
fuse.
3. Check for low voltage conditions and/or proper extension
cord.
4. Disconnect the other electrical appliances from circuit or
operate the compressor on its own branch circuit.