Unit installation

Use and Maintenance Manual Air-cooled water chillers and Heat Pumps R-PAE/R-PAH/EAH Rev. 1 del 03/09
4. INSTALLATION
4.1 Identification tag
The data for the identification of the unit are marked on a permanent tag (Picture 18).
Picture 18 – Identification tag
The correct unit identification by means of the serial number is essential for the execution of any
operation to carry out on the unit. The serial number must be always advised whenever
submitting a request of technical service support.
4.2 Reception and inspection
It is very important to check the packing integrity immediately upon delivery. In case the packing is found damaged, it is
necessary to accept the goods “with reservation” and indicate on the consignment note the state of the received goods
and let the driver countersign it. Any claim concerning the delivered material must be sent to the manufacturer by fax or
by registered letter within 8 days from the receiving date. It is advisable to unpack the unit only when the installation
begins and possibly after the unit has been moved to the location where it must be installed.
It is forbidden to stack units, even if they are packed. If the unit is stored after receiving, it must be not
exposed to weather agents, even if packed .
16