Unit installation

Use and Maintenance Manual Air-cooled water chillers and Heat Pumps R-PAE/R-PAH/EAH Rev. 1 del 03/09
Warning: on the first startup, duly fill in the relevant report attached to this manual and
send a copy to Emicon A.C. (Customer Service), in order to make the warranty valid.
1.5 Readers of the Manual
This manual and all its attachments are supplied with the described unit. The manual must be kept by the machine’s
owner in a proper place. To this end, a plastic bag where to store the manual has been placed inside the machine so that
it can be always easily accessible for consultation and at the same time, it can be preserved in a good state.
All people authorized to operate with the unit, in particular, all technicians assigned to the unit maintenance, must
know all information and instructions contained in this manual.
In case the manual is lost or deteriorated, a new copy must be requested directly to the manufacturer.
2. MAIN SAFETY RULES
2.1 General warnings
Read carefully the whole handbook before performing any operation on the unit. Only qualified
and trained technicians must perform any operation on the machine.
Do not touch the machine if with bare feet or with humid or wet parts of the body.
Do not perform any cleaning operation before the main switch is “OFF” and power line disconnected.
Do not spread, leave unattended or to the reach of children any packaging material (carton box,
staples, plastic bags, etc.) as they may be a source of danger.
2.2 Allowed use
RAE - H: packaged air cooled water chillers intended for air-conditioning and/or industrial systems. They are
designed for external installation (units with axial fans) or for internal installation (units with centrifugal fans).
PAE - H : packaged air cooled heat pumps intended for air-conditioning and/or industrial systems. They are
designed for external installation (units with axial fans) or for internal installation (units with centrifugal fans).
2.3 Forbidden use
Do not use the machine:
Ø For other use than that described in paragraph 2.2;
Ø When it is exposed to rainfall, especially when the unit is designed for internal installation;
Ø in atmosphere with high risk of fire or explosion;
Ø in spaces with corrosive atmosphere;
Ø to heat or cool aggressive fluids for copper, carbon steel and stainless steel.
Any operation on the unit must be carried out in compliance with local technical standards .
3