Operation Manual

19 | ENGLISH
5.6 Completing the installation of the signal booster
1. Type ‘http://192.168.8.200’ in the address bar to connect to the signal booster.
2. Click ‘Setup Tool’.
3. You will now be asked for a ‘Username’ and a ‘Password’. Fill out ‘admin’ in the
‘Username’ field and ‘admin’ in the ‘Password’ field and press the enter key.
4. Click ‘Advanced Setup’ in the left menu.
5. Click ‘Wireless’ in the left menu.
6. Click ‘WDS Setup’ in the left menu.
7. Click ‘AP Scan’ in the right screen.
8. A screen appears. A summary of found wireless networks will be displayed.
9. Click with the left mouse button on the name (SSID) of your wireless router.
10. Click ‘Add’ in the right screen.
11. Click ‘Save’ at the top of the right screen.
12. Click ‘OK’ to save the settings.
13. Now remove the network cable between both the wireless router and signal
booster.
14. You have now completed the settings. You can now place the signal booster to
the location where the wireless signal was weak.
Hint: To make sure there is a wireless connection between both devices, you can try
to connect to both devices with the still connected computer. If correct, you can still
access both devices on their web pages. If this does not work, you can repeat the
steps shown in chapter 5.
6.0 Configuring the router as a signal booster
(Wireless Multi Bridge)
If your own modem or your other wireless router has no support for WDS, you can
setup the EM4510 as a signal booster by using the Wireless Multi Bridge option.
Using this option, the Eminent router will connect to your wireless modem or router
using the same technique as your computer does. Once the Eminent router has
established a connection with your wireless modem or router, the Eminent router has
an internet connection. The Eminent router will also broadcast another wireless signal
which your computer can connect to. Your computer will then have an internet
connection.
Use the following steps to setup a Wireless Multi Bridge connection: