Install guide

ENGLISH

5.0 Configuring the router as a signal booster

(WDS)

Do you already have a wireless network and do you like to increase the range of the

wireless signal? Then connect the router as a signal booster. In order to realize this,

several settings of your signal booster (2) and of your wireless router / access point (1)

must be modified. In the example below we use 2 pieces EM4544.

Note: WDS is not a standard protocol and may not work between different brands and

models. If you are facing problems please refer to the chapter “Configure the router as

a signal booster (Wireless Multi Bridge).

A 2

EM4544 as signal repeater

5.1 Connecting the signal booster (2)

1. Turn off your computer.

2. Connect the router to a wall outlet using the supplied power adapter.

3. Connect the supplied UTP network cable to the ‘LAN 1’ port of the router.

4. Connect the other end of the UTP network cable to the network adapter of your

computer.

Is my router correctly connected to the wall outlet? You can check this by verifying that

the POWER LED is on.

(1)

(2)