Operation Manual

ENGLISH

3.3 Cross Band technology

If your performance and signal strength are ok on both bands we advise to determine

which band is used by the most (preferably by all) WiFi clients and use the opposite

band to communicate between the EM4592 and your modem/router, and connect your

WiFi clients to the other band. In this case the EM4592 can provide the best

performance between WiFi clients and modem/router.

2.4GHz WiFi clients connected to the EM4592 and the EM4592 connected to the

modem/router by 5GHz (see picture Cross-Band 1)

5GHz WiFi clients connected to the EM4592 and the EM4592 connected to the

modem/router by 2.4GHz (see picture Cross-Band 2)

Note: We advise to use the 5GHz band to communicate between the EM4592 and the

modem/router for best performance. Please use the 2.4GHz band if you prefer

coverage above performance, or when you only have a single band router.

Note: If a WiFi client is connected to the EM4592 and uses the same band as the

connection between EM4592 and modem/router. The EM4592 will have to wait for the

data package to be send from the WiFi client to the Repeater before it can send the

data package to the modem/router this applies for communication in both directions. In

this case the network speed is reduced by 50%. If the WiFi client uses the opposite

band to communicate with the EM4592 the network speed is not reduced by 50%.

Cross-Band 1

Cross-Band 2