Operation Manual

ENGLISH

*Refer to the manual of your wireless router for the exact duration of pressing the

WPS button. This can differ from brand or model.

5. Now press the WPS button on the EM4592 Wireless Repeater for approximately 5

seconds. Refer to the following image for the WPS button:

6. The connection between your wireless router and the EM4592 wireless repeater

will be established automatically (this will take approx. 1 minute including reboot).

The signal indicator will stop flashing and indicate the signal strength.

Note: If a modem/router is sending out SSIDs on both 2.4GHz and 5GHz bands at the

same time, priority of connection over WPS will be 2.4GHz 1st, then 5GHz 2nd. If you

prefer the connection between the modem/router and the EM4592 will be 5GHz

please connect to the WiFi network using the WebGUI.

Note: If the WPS button is used, the SSID and network key and frequencies are the

same as used on your wireless router. Some WPS routers will change their original

SSID to another SSID if WPS is used. In this installation guide, the SSID of the

wireless router is ‘Eminent’.

If you wish to use different settings from your modem/router you will need to setup the

EM4592 manually using a web browser.

4.2 Manual configuration using encryption key

1. Connect the EM4592 to a wall outlet (preferably close to the modem/router).

2. Wait for the signal indicator to flash green.

3. Connect to the EM4592 via WiFi SSID: Eminent_repeater or

Eminent_repeater(5G), or use the Ethernet cable to connect to the EM4592

directly.

4. Your device should open your internet browser and will be redirected to the

EM4592 repeater’s user interface. (If in any case it doesn’t, type http://10.0.10.254

in your internet browser and then hit Enter).

WPS button