Install guide

ENGLISH

3. Ethernet indication LED (blue) – this LED is to indicate if the Ethernet link is ok

and packet traffic is sending/receiving. When the Ethernet cable is connected, the

LED is on. When there is packet sending/receiving, the LED is blinking blue light.

4. SD card indication LED(yellow) – this LED is to indicate the status of the Micro-SD

card recording, it will be on when the Micro-SD card is inserted and will blink

during recording.

5. WPS button – this is to automatically synchronize the Wi-Fi settings with a WPS

capable Wi-Fi router.

6. PIR sensor – for the detection of movement.

7. Light detector – for light intensity detection to be able to switch automatically

between Day and Night

8. IR LED – for the Infra-Red lighting of the night mode usage.

9. Infrared Thermometer – detects the environment temperature

10. Microphone – for receiving the audio/voice. Effective distance is about 5 meters.

11. Internal Speaker – for two way audio and speaker alarm usage.

12. Speaker jack – connect to an external speaker for two way audio and speaker

alarm usage.

13. Micro-SD card slot – for inserting the Micro-SD Card. (support up to 32G bytes)

Major components in the front and side panel

The components on the back and bottom panel of the EM6250HD are the bracket

screw jack, power jack, Ethernet jack and reset button:

1. Bracket screw jack – this is the position to screw in the bracket of the EM6250HD.

With the bracket, you can put the EM6250HD on the desk, on the wall or on the

ceiling.

2. Power jack – this is the place to plug in the power adapter. The power needed for

this EM6250HD is 12V/1.0A or 5V/1A, please make sure you are using the correct

power adapter.

3. Ethernet jack – this is the place to plug in the RJ45 Ethernet cable. When the

Ethernet link is ok, the Ethernet indication LED on the front side will be blue light.