EM6514 e-Domotica Wall Switch Sensor
| ENGLISH EM6514 e-Domotica Wall Switch Sensor Table of contents 1.0 Introduction ...........................................................................................................2 1.1 Functions and features ......................................................................................2 1.2 Packing contents ...............................................................................................3 2.0 Using the sensor ................................................................
| ENGLISH 1.2 Packing contents The following parts need to be present in the packing: • EM6514 e-Domotica Wall Switch Sensor • Manual 2.0 Using the sensor In the following figure you can see one of the most common situations to use an EM6514 Wall Switch Sensor in combination with the EM6556 Mini Switch. By using the EM6556 Mini Switch (sold separately, not included) you are able to use your existing wall switch to activate a scene at your own desire.
| ENGLISH 2.2 Use case example: Change your (living) room into the right ambience Want to set your room into the right ambience? No problem! Use an EM6514 Wall Switch Sensor in your (living) room to trigger your self-defined scene. For example, this scene can power up your TV, dim the lights near the TV and switch off other lights in your room. The benefits of doing this: • Using your existing wall switch to enable more devices instead of only a ceiling light.
| ENGLISH 10. Test whether the device works by pressing the button on the sensor. (Be careful and avoid touching the wires). The LED on the sensor will be lit. The connected device will also be turned on. 11. Do not close the junction box yet. 3.2 Assigning the sensor to the e-Domotica e-Centre There are two situations possible when assigning the sensor to the e-Centre. 1. 2. You assign the sensor to the e-Domotica e-Centre during the installation process of the e-Centre itself.
| ENGLISH 10. You can now put the sensor in the wall switch box. We suggest to disable the mains by turning off the main switch of the house when putting the sensor in the wall switch box. 4.0 Removing the sensor In some cases it might be necessary to remove (exclude) the sensor from your eCentre. Follow these instructions to do so: 1. Make sure your computer is completely started. 2. Open you computer’s web browser. 3.
| ENGLISH Q: A: A: A: A: A: How do I include or exclude the sensor into a different Z-wave controller Inclusion: Have your Z-wave Controller entered inclusion mode, press the On/off button of the sensor three times. Exclusion: Have your Z-wave Controller entered inclusion mode, press the On/off button of the mini switch three times. Once the node has been included, the LED will go into an interval of two seconds on and two seconds off.
| ENGLISH 6.0 Service and support This users manual has been carefully written by Eminent’s technical experts. If you have problems installing or using the product, please fill out the support form at the website www.eminent-online.com/support. You can also contact us by phone. Below you will find a list with phone numbers for each supported country.
| ENGLISH 8.0 Warranty conditions The five-year Eminent warranty applies to all Eminent products unless mentioned otherwise before or during the moment of purchase. When having bought a secondhand Eminent product the remaining period of warranty is measured from the moment of purchase by the product’s first owner. The Eminent warranty applies to all Eminent products and parts inextricably connected to and/or mounted on the main product.
| ENGLISH 9.0 Declaration of Conformity To ensure your safety and compliance of the product with the directives and laws created by the European Commission you can obtain a copy of the Declaration of Conformity concerning your product by sending an e-mail message to: info@eminentonline.com. You can also send a letter to: Eminent Computer Supplies P.O.
