manual

5 | ENGLISH
10. Test whether the device works by pressing the button on the sensor. (Be careful
and avoid touching the wires). The LED on the sensor will be lit. The connected
device will also be turned on.
11. Do not close the junction box yet.
3.2 Assigning the sensor to the e-Domotica e-Centre
There are two situations possible when assigning the sensor to the e-Centre.
1. You assign the sensor to the e-Domotica e-Centre during the installation process
of the e-Centre itself. The installation wizard of the e-Centre will move along
several steps during the installation process of the e-Centre itself, meaning you
can add all your e-Domotica devices through the e-Centre’s own website
“http://ecentre”. For this installation you have to follow the steps shown on
screen.
2. You can add your sensor to the already installed e-Centre. This is described in
the next chapter.
Note that you might need to enable the checkbox ‘Normal/High Power’ just below the
‘Include’ button on the ‘e-Domotica Products’ page of your e-Centre. This option is
available to be able to include devices on a greater range. For example, your e-Centre
is located in the living room and the sensor is located in the attic of your house.
3.3 Adding the sensor to the already installed e-Domotica
e-Centre
1. Make sure your computer is completely started.
2. Open your computer’s web browser.
3. Fill in “http://ecentre” in the address bar of your web browser and press the
‘Enter’ key on your keyboard.
4. The webpage of the e-Centre will be shown. If the Wizard is started, click ‘Exit
Wizard’ to go to the ‘e-Domotica Products’ page.
5. Click the ‘Include’ button. The e-Centre will start to search for new e-Domotica
devices.
6. Press the button on your new sensor three times.
7. A message will appear: ‘Product found’.
If the device is not found, press the ‘Exclude’ button in the e-Centre’s webpage and
then click the button on your sensor. After this procedure you can add the new device
correctly.
8. Give the connected and found device a name, choose a location and click ‘Save’.
9. The sensor has now been added to the e-Centre. The e-Centre will now be able
to read the sensor.