manual
8 | ENGLISH
b. If not: Run a black switching wire to the first wall switch and connect this
to the white switching wire.
9. Select one of the options below depending on your situation.
a. Multiway switching situation using all wires:
If you use two light switches on the wall: Connect one of the two the
black switching wires to the switching wire coming from the second wall
switch.
b. Multiway Switch and Single switch situation: If you use only one light
switch on the wall: Connect a terminal block to the second non used
black switching wire from the EM6557.
10. Make sure all wires are fully inserted into the terminal or wire nuts.
11. Turn on the main switch to enable the mains again.
12. Test whether the device works by pressing the button on the switch. (be careful
and avoid touching the wires). The LED on the switch will be lit. The connected
device will also be turned on.
13. Do not close the junction box yet.
3.2 Assigning the Built-In switch to the e-Domotica e-
Centre
Note that you might need to enable the checkbox ‘Normal/High Power’ just below the
‘Include’ button on the ‘e-Domotica Products’ page of your e-Centre. This option is
available to be able to include devices on a greater range. For example, your e-Centre
is located in the living room and the EM6557 is located in the attic of your house.
1. Make sure your computer is completely started.
2. Open your computer’s web browser.
3. Enter “http://ecentre” in the address bar of your web browser and press the
‘Enter’ key on your keyboard.
4. The webpage of the e-Centre will be shown. If the Wizard is started, click ‘Exit
Wizard’.
5. Go to the ‘e-Domotica Products’ page.
6. Click the ‘Include’ button. The e-Centre will start to search for new e-Domotica
devices.
7. Press the button on your new switch three times.
8. A message will appear: ‘Product found’.
If the device is not found, press the ‘Exclude’ button in the e-Centre’s webpage and
then click the button on your switch. After this procedure you can add the new device
correctly.
9. Give the connected and found device a name, choose a location and click ‘Save’.
10. The switch has been added to the e-Centre. The e-Centre will now be able to
control the switch.