User manual

14 | ENGLISH
FTP Service Settings
1. Click ‘FTP Service Settings’.
2. Fill in the data of your FTP server.
3. If a mark is placed at ‘Upload Image Now’, you can set an interval. Choose a ‘10
seconds’ interval to upload a camera image to your FTP server every ten
seconds.
Alarm Service Settings
1. Click ‘Alarm Service Settings’.
2. Place a mark at ‘Motion Detect Armed’ and/or at ‘Alarm Input Armed’. If a mark is
placed, the camera will attend you to motion detection or an alarm notification.
3. For example, if ‘Send mail on alarm’ is selected, a mail will be send to the
receivers. If ‘Upload image on alarm’ is selected, an image will be send to your
FTP server.
Upgrade Device Firmware
1. Click ‘Upgrade Device Firmware’.
2. Using this menu, you can upgrade the firmware (system software) of the camera.
Bear in mind that the firmware needs to be saved on your computer, and the
firmware file needs to be unpacked.
Backup & Restore Settings
1. Click ‘Submit’ to make a backup of your current camera settings.
2. You can restore a previous setting by browsing to a previous backup file and click
the ‘Submit’ button to restore this configuration.
Restore Factory Settings
1. Click ‘Restore Factory Settings’.
2. The camera will ask a confirmation. If confirmed, the camera will be brought back
to factory settings.
Reboot Device
1. Click ‘Reboot Device’.
2. The camera will ask a confirmation. If confirmed, the camera will be restarted.
Any changes you have made will be saved.
Log
1. Click ‘Log’.
2. An overview will be shown. This overview contains information about the
computers which have logged in to the camera. The IP Addresses of the
computers are shown, and also, the privileges of these computers are shown.