EM6575 - Wireless indoor siren
| ENGLISH EM6575 - Wireless indoor siren Warnings and points of attention Due to laws, directives and regulations set out by the European Parliament, this device could be subject to limitations concerning its use in certain European member states. In certain European member states the use of this product could be prohibited. More information regarding this warning can be found in the Declaration of Conformity on the last page of this document! Table of contents 1.0 Introduction .........................
| ENGLISH EM6575 gives you a warning by using a loud sound signal and by flashing a red strobe light. This way, everybody inside the building will be warned. Thanks to the repeater function of e-Domotica switches and dimmers, the EM6575 can be used everywhere in your house or building. 1.2 Packaging contents • • • Eminent EM6575 Z-Wave Siren 4 batteries Manual 1.3 Explanation of the EM6575 1. 2. 3. 4. 5. Tamper button of the EM6575. Link button. Jumper (near link-key) ON means high volume.
| ENGLISH 2. you can add all your e-Domotica devices through the e-Centre’s own website ‘http://e-Centre’. For this installation you have to follow the steps shown on screen. You have to press the ‘Link’ button when e-Centre is searching for devices. You can add your siren to the already installed e-Centre. This is described in chapter ‘Adding the siren to the already installed e-Centre’. 2.3 Adding the siren to the already installed e-Centre 1.
| ENGLISH 3. 4. 5. Then take the back plate and make sure the three holes in the back plate correspond with the three drilling holes. Fix the back plate using the three supplied screws. Slide the EM6575 onto the back plate. Use the screw on the bottom of the back plate to secure the back plate to the EM6575. 3.0 Adding scenarios Once the EM6575 has been added and has been assigned, you can add a scenario to this device.
| ENGLISH 1. 2. 3. 4. Press the ‘Security’ button on the e-Centre. Your pin code will be asked. Fill in your pin code and press the ‘OK’ button. The e-Centre will start to count down. Once the count down has been finished, the e-Centre is armed. If the EM6570 is triggered, the alarm of the EM6500 and EM6575 will sound. To interrupt the sound alarm of the EM6500 and EM6575, fill in your pin code again and press the ‘OK’ button. The sound alarm will stop.
| ENGLISH website www.eminent-online.com/support. You can also contact us by phone. Below you will find a list with phone numbers for each supported country. Country Belgium (Dutch) Belgium (French) Denmark Finland Germany Italy Norway Spain Sweden The Netherlands UK Phone number 070 277 286 070 277 286 +45 69918565 +35 8942415826 1805 982 234 +39 0240042016 +47 21075033 807 080 042 +46 840 309985 0900-3646368 905 871 0013 Rate per minute* €0.30 €0.30 Local Costs Local Costs €0.
| ENGLISH Clearly state ‘Declaration of Conformity’ and the article code of the product of which you would like to obtain a copy of the Declaration of Conformity.
EM6575 | 02-2010