EM6580 e-Domotica motion sensor
| ENGLISH EM6580 e-Domotica motion sensor Warnings and points of attention Due to laws, directives and regulations set out by the European Parliament, this device could be subject to limitations concerning its use in certain European member states. In certain European member states the use of this product could be prohibited. More information regarding this warning can be found in the Declaration of Conformity on the last page of this document! Table of contents 1.0 Introduction.........................
| ENGLISH 1.2 Packing contents The following parts need to be present: • • • EM6580 wireless e-Domotica motion sensor 3 AA batteries User manual 2.0 Using the EM6580 Only a few short and simple steps are necessary to connect the motion sensor, and assign the EM6580 to your e-Centre and enjoy the use of the EM6580. Use the following steps to connect the motion sensor. 2.1 Placing the batteries 1. 2. Remove the bottom of the EM6580 motion sensor by removing the 2 screws.
| ENGLISH 6. Place the new motion sensor close to the e-Centre (30 cm as maximum distance). When assigning the new motion sensor, a shorter distance is required compared to being in service. 7. 8. Press the button of your new motion sensor (This button is located at the bottom of the EM6580). A message will appear: ‘Product found’. If the device is not found, press the ‘Reset’ button in the e-Centre’s webpage and then click the button on your motion sensor.
| ENGLISH If the motion sensor is placed at a distance of more than 25 meters, place the motion sensor at the desired location. Choose ‘e-Domotica products’ in the e-Centre’s webpage, then choose the ‘Optimize’ option. By doing so, your wireless network will be optimized for maximum range. Note: In order to use the alarm function, we refer to the user manual of the Eminent eCentre. 2.5 Removing the motion sensor 1. 2. 3. 4. 5. 6. 7. Make sure your computer is completely started.
Warranty conditions The five-year Eminent warranty applies to all Eminent products unless mentioned otherwise before or during the moment of purchase. When having bought a secondhand Eminent product the remaining period of warranty is measured from the moment of purchase by the product’s first owner. The Eminent warranty applies to all Eminent products and parts inextricably connected to and/or mounted on the main product.
