User manual

ENGLISH

1.2 Packing contents

The following parts need to be present:

• EM6580 wireless e-Domotica motion sensor

• 3 AA batteries

• User manual

2.0 Using the EM6580

Only a few short and simple steps are necessary to connect the motion sensor, and

assign the EM6580 to your e-Centre and enjoy the use of the EM6580. Use the

following steps to connect the motion sensor.

2.1 Placing the batteries

1. Remove the bottom of the EM6580 motion sensor by removing the 2 screws.

2. Place the batteries in the battery compartment. Place the outer batteries first,

then place the battery in the middle. Do not place the bottom back.

2.2 Assign the motion sensor to the Eminent e-Centre

There are two possible situations when assigning the motion sensor to the Eminent

e-Centre.

1. The motion sensor will be assigned to the Eminent e-Centre during the initial

installation process of the e-Centre. The installation wizard of the e-Centre will

move along nine steps to complete the installation of all your e-Domotica

devices, using the e-Centre’s own website “http://e-Centre”. Therefore, follow the

steps on screen. Use the metal button at the back during the installation

procedure.

2. Assign the motion sensor to the already installed e-Centre. This is described in

chapter ‘3.3 Add the motion sensor to the already installed e-Centre’.

2.3 Add the motion sensor to the already installed

e-Centre

1. Make sure the computer is turned on and is completely started.

2. Open your computer’s web browser.

3. Fill in “http://e-Centre” in the address bar of your web browser and press the

‘Enter’ key on your keyboard.

4. The openings screen of the Eminent e-Centre will be shown.

5. Click the ‘Add’ button, the e-Centre will start to search for new e-Domotica

devices.