EM6615 e-Domotica Electronic Switch Insert
| ENGLISH EM6615 e-Domotica Electronic Switch Insert Table of contents 1.0 Introduction................................................................................................................. 2 1.1 Functions and features .......................................................................................... 2 1.2 Packing contents.................................................................................................... 3 1.3 Technical Drawings.........................................
| ENGLISH the maximum permissible load is reduced as follows, due to the restricted heat dissipation: Load reduction by Electronic switch insert installed in cavity or wooden walls* Several electronic switch inserts or in combination with dimmer* X Electronic switch insert in 1-gang or 2gang surfacemounted housing Electronic switch insert in 3-gang surfacemounted housing 25% X 30% X 50% * If several factors apply at once, add the load reductions together. 1.
| ENGLISH Figure 2, 3 and 4 2.0 How to install the electronic switch insert Risk of fatal injury from electrical current. If you do not have enough electrical skills, do not continue and let a certified electrician do the job for you. Otherwise you might get injured and/or electrocuted. Observe the country specific regulations. Risk of fatal injury from electrical current. The output may carry an electrical current even when the load is switched off.
| ENGLISH and let it slip onto the pin (1A) of the insert. Once it has been attached, the plug at the back provides the connection for supplying power and exchanging data. 3.1 Add the switch to an e-Domotica e-Centre 1. 2. 3. 4. 5. 6. 7. 8. Make sure your computer is completely started. Open your computer’s web browser. Enter “http://ecentre” in the address bar of your web browser and press the ‘Enter’ key on your keyboard. The webpage of the e-Centre will be shown.
| ENGLISH Figure 5 1. 2. Check if the mains is switched off using a insulated phase tester for example. Figure 5: Pull the fuse holder out towards the front and replace fuse C (replacement fuse D). 6.0 How to clean the sensor cover Attention: cleaning with detergents or wet cloths can damage the device. Only ever clean the device with a dry cloth. 7.0 What should I do if there is a problem? The load cannot be operated locally using the sensor cover.
| ENGLISH 2. Then press and hold the sensor button for approx. five seconds until the connected load turns off. The sensor cover has been reset to its factory settings. Caution: When you reset to the factory settings, all the settings and connections for this device are lost. The Z-wave system may no longer work and will need to be reconfigured. 8.0 Frequently Asked Questions The latest frequently asked questions for your product can be found on the support page of your product.
| ENGLISH Always follow up the instructions in the manual, especially where it concerns devices which need to be assembled. Warning: In most cases this concerns an electronic device. Wrong/improper use may lead to (severe) injuries! Repairing of the device should be done by qualified Eminent staff. The warranty immediately voids when products have undergone self repair and/or by misuse. For extended warranty conditions, please visit our website at: www.e-domotica.
| ENGLISH 12.0 Declaration of Conformity To ensure your safety and compliance of the product with the directives and laws created by the European Commission you can obtain a copy of the Declaration of Conformity concerning your product by sending an e-mail message to: info@eminentonline.com. You can also send a letter to: Eminent Computer Supplies P.O.