Operation Manual

5 | ENGLISH
and let it slip onto the pin (1A) of the insert. Once it has been attached, the plug at the
back provides the connection for supplying power and exchanging data.
3.1 Add the switch to an e-Domotica e-Centre
1. Make sure your computer is completely started.
2. Open your computer’s web browser.
3. Enter “http://ecentre” in the address bar of your web browser and press the
‘Enter’ key on your keyboard.
4. The webpage of the e-Centre will be shown. If the Wizard is started, click ‘Exit
Wizard’.
5. Go to the ‘e-Domotica Products’ page.
6. Click the ‘Include’ button. The e-Centre will start to search for new e-Domotica
devices.
7. Press the sensor button on the switch three times within 1,5 seconds.
8. A message will appear: ‘Product found’.
If the device is not found, press the ‘Exclude’ button in the e-Centre’s webpage and
then click the button on your switch. After this procedure you can add the new device
correctly.
9. Give the connected and found device a name, choose a location and click ‘Save’.
10. The switch has now been added to the e-Centre. The e-Centre will now be able
to control the switch.
4.0 How to operate the switch
You can operate the switch by means of the following operating elements:
• Locally using the sensor cover
• EM6505 e-Domotica e-Centre
• EM6511 e-Domotica Remote Control (using a scene)
• Smart phone or tablet
5.0 How to replace the fuse
Risk of fatal injury:
Switch off the mains voltage before you continue.