EM6620 e-Domotica Super Dimmer Insert
| ENGLISH EM6620 e-Domotica Super Dimmer Insert Table of contents 1.0 Introduction................................................................................................................. 2 1.1 Functions and features .......................................................................................... 2 1.2 Packing contents.................................................................................................... 3 1.3 Technical Drawings..............................................
| ENGLISH If the load is too high, it will trigger the dimmer's overload protection. When the connected load is reduced, the overload protection switches off and the dimmer switches back on. Caution: Connected devices can be damaged if you connect mixed loads (inductive and capacitive) at the same time. Note: Do not use dimmers on socket-outlets! The risk of overloading and the risk of unsuitable appliances being connected is too high.
| ENGLISH 1.3 Technical Drawings Figure 1 and 2 Figure 3 and 4 2.0 How to install the dimmer Risk of fatal injury from electrical current. If you do not have enough electrical skills, do not continue and let a certified electrician do the job for you. Otherwise you might get injured and/or electrocuted. Observe the country specific regulations. Risk of fatal injury from electrical current. The outputs may carry an electrical current even when the load is switched off.
| ENGLISH 1. 2. Wire the dimmer for the desired application: a. Figure 3: Dimmer A as a stand-alone device b. Figure 4: Dimmer A with extension units: Example of connection with a push-button B, an extension insert C and an extension TELE insert D. Install the dimmer (Figure 2). Note: A neutral conductor is required if the extension TELE insert is used Caution: The plug prongs on the rear of the sensor cover can become bent if tilted excessively.
| ENGLISH 3. The dimmer has detected the load and is ready for operation. Note: The lights will flicker in this way (load detection) after every interruption in the mains voltage. 4.1 Add the dimmer to an e-Domotica e-Centre Note that you might need to enable the checkbox ‘Normal/High Power’ just below the ‘Include’ button on the ‘e-Domotica Products’ page of your e-Centre. This option is available to be able to include devices on a greater range.
| ENGLISH 5.2 Switching the memory function on/off Switch the dimmer on and off at least ten times in quick succession. 6.0 How to clean the sensor cover Attention: Cleaning with detergents or wet cloths can damage the device. Only ever clean the device with a dry cloth. 7.0 What should I do if there is a problem? The load cannot be operated locally using the sensor cover. Make sure that the sensor cover is properly attached to the insert. The load cannot be operated using the transmitter button.
| ENGLISH 8.0 Frequently Asked Questions The latest frequently asked questions for your product can be found on the support page of your product. Eminent will update these pages frequently to assure you have the most recent information. Visit www.e-domotica.com/support/faqs for more information about your product. 9.0 Service and support This users manual has been carefully written by Eminent’s technical experts.
| ENGLISH Repairing of the device should be done by qualified Eminent staff. The warranty immediately voids when products have undergone self repair and/or by misuse. For extended warranty conditions, please visit our website at: www.e-domotica.com/support/warranty *Tip: Eminent e-Domotica manuals are written with great care. However, due to new technological developments it can happen that a printed manual does not longer contain the most recent information.
| ENGLISH 12.0 Declaration of Conformity To ensure your safety and compliance of the product with the directives and laws created by the European Commission you can obtain a copy of the Declaration of Conformity concerning your product by sending an e-mail message to: info@eminentonline.com. You can also send a letter to: Eminent Computer Supplies P.O.