User manual

6 | ENGLISH
1. Take your EM7080 and remove the screws on all four corners on the bottom of
the device.
2. Gently remove the lid. Be careful, the fan is connected to main board!
3. Disconnect the fan from the fan connector. Note the orientation of the connector.
4. Place the lid safely out of the way for now.
5. Lower the SATA hard disk into the media player.
6. Note the grey SATA connector on the main board, and slide the disk into it.
7. Push the SATA hard disk towards the SATA connector until the connection is
locked down tight.
8. The hard disk will now be resting on two pins that will hold the hard disk in place
if it is aligned correctly. Do not hold the device upside down from this point!
9. Put the EM7080 on its side, and screw in the two larger screws to hold the hard
disk in place.
10. Put the EM7080 back on its feet, and place the lid back in closed position.
11. You can now safely flip over the EM7080 and screw back the four small screws
in all four corners of the device.
12. You’re done, the EM7080 is now ready to use the internal hard disk.
If you are using a new hard disk, then use the steps in chapter 6.1 to prepare the hard
disk for usage.
5.0 Connecting the media player to your
television
5.1 Connecting to your television using HDMI
(Recommended)
The best image quality can be obtained by connecting the media player to your
television using a HDMI cable. Of course, your television needs to be equipped with a
HDMI connection.
1. Connect the HDMI cable to the HDMI output of the media player.
2. Connect the other side of the HDMI cable to an available HDMI input of your
television.
Note: Make sure your media player and television are both turned off before
connecting your cables. This way you can prevent any possible damage to your
devices.