Operation Manual

7 | ENGLISH
5.0 Connecting the media player
1. Connect the HDMI cable to the HDMI connection of the EM7282 and connect the
other side of the HDMI cable to a free HDMI connection on your television. You
can also make use of the composite connection when using an older CRT
television.
2. Connect the antenna (cable) to the antenna connection of the EM7282.
3. If desired, connect a network cable to the LAN connection of the EM7282.
Connect the other side of the network cable to your router or switch.
4. Set the television to the corresponding HDMI channel.
5. Connect the cable of the power supply to the ‘DC 12V’ of the media player.
6. Connect the power supply to a wall outlet.
In case you want to use a HDMI receiver, you need to connect the HDMI cable to both
media player and HDMI receiver.
6.0 Setting up the media player
6.1 Using the wizard (Initial setup)
The moment the power supply has been connected to a wall outlet, the media player
automatically starts. Usually, a wizard will be shown. This wizard can be used to setup
the media player.
1. The wizard starts with the menu language. Press the ‘OK’ button to enter the
language selection. In this case, select ‘English’ and press the ‘OK’ button.
2. ‘TV Region’ is selected. Press the ‘OK’ button and select your TV region. Press
the ‘OK’ button to continue.
3. ‘Channel Scan’ is the next selected item. Press the ‘OK’ button. ‘Automatic Scan’
is selected by default. Press the ‘OK’ button after which the media player starts
searching for available TV and Radio channels. A progress bar will be shown.
Press the ‘OK’ button when the ‘Automatic Scan’ is finished.
4. The next item is ‘Time’. Press the ‘OK’ button to enter the ‘time’ menu. Select the
Year, Month and Day. Also, the current time can be set using the H(our),
M(inutes) and S(econds) . When set, press the ‘OK’ button and confirm your
selection by selecting ‘Yes’ and press the ‘OK’ button again.
5. Then ‘Wired LAN Setup’ is selected. Press the ‘OK’ button to enter the selection
menu. If the media player has been connected using a network cable, you can
select ‘DHCP IP (AUTO)’ to automatically assign an IP-Address to the media
player. Press the ‘OK’ button. DNS (AUTO) is shown. Press the ‘OK’ button.
Press the ‘OK’ button to save the settings. If you want to manually set the IP-
Address, you need to select ‘FIX IP (MANUAL)’ and fill out the necessary data.
Press the ‘OK’ button to confirm your input and follow the steps shown on screen.
The connection will be tested.
Downloaded from www.Manualslib.com manuals search engine