Operation Manual

15 | ENGLISH
3. If the media player will be used mainly during night-time, the ‘Night Mode’ can be
set to ‘ON’ or ‘Comfort’. When set to ‘On’, low-level audio content such as dialog
will be increased making it easier to hear at low volume levels. When set to
‘Comfort’, the intensity of higher-level audio content will also be reduced.
4. Select ‘SPDIF Output’ and press the ‘OK’ button. Set ‘SPDIF Output’ to ‘RAW’.
5. Select ‘Surround Sound’ and press the ‘OK’ button. Select ‘5.1 CH’ or ‘Don’t
Care’ and press the ‘OK’ button.
6. The last item is ‘Lip Sync’. Usually, ‘AUTO’ is the default setting and is the
recommended setting. Only set the ‘Lip Sync’ option if you experience delay in
audio playback. The maximum setting for lip sync is 500. However, some SPDIF
receivers also have a ‘Lip Sync’ option. It is advisable to use the lip sync option
on the receiver, since most receivers are able to delay and speed up the sound.
7.4 Setting up the network
During the wizard, the initial network setup was available. The network settings can be
changed afterwards if necessary. The EM7385 also has a built-in WIFI module, which
allows you to easily setup the wireless connection. The EM7380 can also connect to
your wireless network by connecting an EM4576/4579 wireless USB stick. During the
next chapter we will explain how wired network settings can be changed and how to
setup a wireless connection.
7.4.1 Wired connection - Automatically using DHCP
1. Use the navigation buttons to go to ‘Setup’ and press the ‘OK’ button.
2. Select ‘Network’.
3. Select ‘Wired Lan Setup’ and press the ‘OK’ button.
4. Choose ‘DHCP IP (AUTO)’ to automatically obtain an IP-Address. Press the ‘OK’
button to confirm.
5. Choose ‘DNS (auto)’ and press the ‘OK’ button, after which the notification ‘Save
network setting appears’. Select ‘Yes’ and press the ‘OK’ button.
6. The connection will be tested. If correct, the notification ‘Connected’ will appear.
Also, an ‘IP-Address’ and ‘Submask’ will be shown. Press the ‘OK’ button.
7. Press the ‘Home’ button to return to the main menu.
7.4.2 Wired connection - Manually
In case your network does not have a DHCP server, or you want to manually ad an IP-
Address, you can use the following steps:
1. Use the navigation buttons to go to ‘Setup’ and press the ‘OK’ button.
2. Select ‘Network’.
3. Select ‘Wired Lan Setup’ and press the ‘OK’ button.
4. Choose ‘FIX IP (Manual)’ and press the ‘OK’ button.
5. Fill out a correct ‘IP-Address’ at ‘IP Address’. This IP-Address needs to be in
range with your network’s IP-Address.
Downloaded from www.Manualslib.com manuals search engine