Operation Manual

45
|
ENGLISH
8.0 Install motion detector
8.1 front of motion detector
LED indicator :
Flashes continuously : Motion detector is performing a self-test
Flashes 1x : Motion detected
Flashes 2x : Self-test completed. Motion detector is active
Flashes once per 3 seconds : Battery power low, exchange battery*
* You will receive a text message if battery level is low. The message contains the
following information (up to sensor 9) Sensor name with additionally the text ‘battery
almost empty’. From sensor 10 the name will be replaced by a zone nr. with
additionally the text ‘battery almost empty’.
Remark: The motion sensor has an energy saving mode.
When the sensor is switched on and there is motion detected in the room within 3
minutes, the sensor will go into energy saving mode. This means the sensor is not
active.
When, after 3 minutes, there is no motion detected anymore the sensor will be back in
active mode.
So when you need to test the sensor, it is very important to wait for at least 3 minutes.
1. Detection window
2. LED indicator
3. Mounting bracket