Operation Manual

3 | ENGLISH
2.1 LED indicators
The LED indicators are inside of the learning button.
Once the repeater is switched on the LED indicator will be lit.
LED Green : The wireless repeater is switched on
LED Blue : The wireless repeater is transmitting data
When both Green en Blue LEDs are flashing, the repeater is in learning or deleting
modus.
3.0 Where to place the wireless repeater ?
The signal repeater should be placed at the correct location.
The distance between the repeater and the control panel should be maximum
300meters (open field). The distance between the repeater and the accessories
should be maximum 90meters (open field).
In below picture you can see the correct location. The motion detector is used as a
sample accessory.
4.0 Add or delete accessories
Each accessory which needs to connect to the alarm system through this wireless
repeater should be paired to the repeater.
Note : First you need to pair the accessory with the alarm system itself !
To add or delete an accessory from the wireless repeater you should set the repeater
in learning or deleting mode.
Switch the repeater ON to activate the learning mode. When the repeater is already
ON, please switch it OFF and ON again. The repeater will go into learning mode now
for about one minute. The Green and Blue LEDs are flashing.