EM8660 Wireless door / window contact (2-way communication)
| ENGLISH EM8660 - Wireless door / window contact Table of contents 1.0 Introduction ........................................................................................................... 2 1.1 Packing contents ............................................................................................... 2 2.0 Front window/door sensor ..................................................................................... 3 3.0 Inside the window/door sensor ............................................
| ENGLISH 2.0 Front window/door sensor LED Indicator Sensor Magnet LED indicator : Flashes 1x : Window/Door is detected as open. Flashes quickly : Battery power low, exchange battery* * You will receive a text message if battery level is low. The message contains the following information (up to sensor 9) sensor name with additionally the text ‘battery almost empty’. From sensor 10 the name will be replaced for a zone nr. with additionally the text ‘battery almost empty’. 3.
| ENGLISH 3.2 Group settings (jumpers) Every sensor can be configured to be added to a single group by setting the jumper settings; home-group, normal group, single group or 24-hours group. Bellow you will see an overview of the meaning and how to configure the jumper settings for that type of zone. Remark : Determine before pairing with the alarm system in which group the sensor will be operational. Once the sensor is successfully paired with the system.
| ENGLISH The distance between the sensor and the magnet must not exceed 1cm. Mount both parts with the supplied double-sided tape. You can also choose to mount the sensor by using screws. It’s not recommended to install the sensor in a room with a lot of metal. Neither mount the sensor on constructions. Always check if the red LED will turn on when the door /window is opened. 4.1 Register the window/door sensor Make sure the sensor and the magnet are located next to each other.
| ENGLISH 6.0 Service and support This users manual has been carefully written by Eminent’s technical experts. If you have problems installing or using the product, please fill out the support form at the website www.eminent-online.com/support. You can also contact us by phone. Below you will find a list with phone numbers for each supported country.
| ENGLISH Repairing of the device should be done by qualified Eminent staff. The warranty immediately voids when products have undergone self repair and/or by misuse. For extended warranty conditions, please visit our website at www.eminentonline.com/warranty. *Tip: Eminent manuals are written with great care. However, due to new technological developments it can happen that a printed manual does not longer contain the most recent information.
| ENGLISH 9.0 Declaration of Conformity Application of Council Directives: Manufacturer’s Name: Eminent Type of Equipment: Wireless Door/Window Contact Equipment Class: Commercial, Light Industrial, Consumer PRODUCTNUMBER: EM8660 Conforms to the following standards: EN301 489-1 V1.8.1:2008 EN50371:2002 EN301 489-3 V1.4.1:2002 EN60950-1:2006 +11:2009+A1:2010 EN300 220-1 V2.3.1:2010 EN300 220-2 V2.3.