Datasheet

5
The meter shows the frequency spectrum of 48-860 MHz. A marker can select a
certain channel (with the “UP”, “DOWN” buttons).
Signallevel (in dBuV) of that channel will be shown in the display also.
- Press the OK-button and the meter will “zoom in” at the frequency which the
marker is pointing at.
Another push on the mode button will take the meter back to Singlechannel-mode
2. Description of functions
2.1 Single channel-mode (view one channel)
In this mode the meter measure analog signal strength on the selected
channel. The higher dB value, the better signal. The maximum signal received
is also indicated. To change the channel, use the UP /DOWN
buttons.
If the unit is feeding power to an antenna it is indicated with the 0V, 5V, 12V or
24V symbol. This function can be selected in the Antenna voltagemenu. The
battery indicator is not shown when the unit is fed by an external power-supply
2.2 Digital-mode (view digital)
PRE- and POST- BER (Bit Error Rate) and C/N (Carrier/Noise) is presented in
this mode.