Instructions

4.6 Entering To The Programming Mode, Changing and Saving Parameters
i
If no operation is performed in Programming mode for 20 seconds, device turns to
operation screen automatically
SV
P
SET
°C
SV
P
SET
°C
Press increment button
for accessing to the
password entering
screen.
SV
P
SET
°C
SV
P
SET
°C
Enter programming
mode accessing
password with
increment and
decrement buttons
Press SET/OK button
for accessing to the
parameters
Operation Screen
Password Entering
Screeen
When SET button is pressed for 5
seconds, “P” led starts to blink. If
programming mode entering password is
different from 0, programming mode
entering screen will be observed.
5 secs
Programming Mode
Entering Screen
Note-2: Parameters can be observed by pressing SET/OK button in
password entering screen without entering the programming mode
entering password. But parameters can not be changed.
Note-1: If programming mode accessing password is 0, hysteresis
screen is observed instead of Programming screen
accessing password
Password Entering
Screeen
SV
P
SET
°C
SV
P
SET
°C
Parameter is accessed
by pressing increment
button. If set button is
pressed, next
parameter is shown.
Hysteresis Parameter
Hysteresis Parameter
Value
Change the
parameter with
increment and
decrement buttons
25