User manual

2.2PanelCut-Out
2.GeneralDescription
2.1FrontViewandDimensionsofESM-3710-NTemperatureController
MountingClamp
PanelSurface
(maximumthickness15mm/0.59inch)
FrontPanel
IP65protection
NEMA 4X
ESM-3710-N77x35 DINSize TemperatureController
InstructionManual.ENGESM-3710-N01V0407/14
-4DigitsDisplay
-NTCInputor
PTCInputor
(Mustbedeterminedinorder.)
- Adjustabletemperatureoffset
-Operationselectionofcompressoroperatescontinuously,
stopsoroperatesperiodicallyincaseofsensordefect
-Compressorprotectiondelays
- Adjustableinternalbuzzeraccordingtosensordefectstatus.
-Passwordprotectionforprogrammingsection
-InstallingparametersusingProkey
-Remoteaccess,datacollectingandcontrollingwithModbusRTU
-HavingCEmarkaccordingtoEuropeanNorms
-
JTypethermocoupleInputor,
KTypethermocoupleInputor,
2-WirePT-100Inputor,
2-WirePT-1000Input
ON/OFFtemperaturecontrol
Selectableheatingorcoolingfunction
-Selectionofoperationwithhysteresis
- Adjustabletemperatureoffset
-
-Setvaluelowlimitandsetvaluehighlimitboundaries
ESM- 77x35DINSize3710-N
Digital,ON/OFFTemperature
Controller
OperatingTemperature:
Max.OperatingHumidity :
Altitude :
0to50°C
90%Rh(non-condensing)
Upto2000m.
Forbidden Conditions:
Corrosive atmosphere
Explosive atmosphere
Home applications (The unit is only for industrial applications)
c
1.2GeneralSpecifications
1.Preface
ESM-3710Nseriestemperaturecontrollersaredesignedformeasuringandcontrolling
temperature. TheycanbeusedinmanyapplicationswiththeirOn/Offcontrolform,heating
andcoolingcontrolformandeasy-useproperties.Someapplicationfieldswhichtheyare
usedarebelow:
ApplicationFields Applications
Glass Heating
Food BakingOvens
Plastic Incubators
Petro-Chemistry Storages
Textile, Automative AirConditioning
MachineProductionIndustriesEtc... Etc...
2
1.1EnvironmentalRatings
3 41615
13 14
A visual inspection of this product for possible damage occurred during shipment is
recommended before installation. It is your responsibility to ensure that qualified mechanical
and electrical technicians install this product.
If there is danger of serious accident resulting from a failure or defect in this unit, power off the
system and separate the electrical connection of the device from the system.
The unit is normally supplied without a power supply switch or a fuse. Use power switch and fuse
as required.
Be sure to use the rated power supply voltage to protect the unit against damage and to prevent
failure.
Keep the power off until all of the wiring is completed so that electric shock and trouble with the
unit can be prevented.
Never attempt to disassemble, modify or repair this unit. Tampering with the unit may results in
malfunction, electric shock or fire.
Do not use the unit in combustible or explosive gaseous atmospheres.
During putting equipment in hole on the metal panel while mechanical installation some metal
burrs can cause injury on hands, you must be careful.
Montage of the product on a system must be done with it’s fixing clamps. Do not do the montage
of the device with inappropriate fixing clamp. Be sure that device will not fall while doing the
montage.
It is your responsibility if this equipment is used in a manner not specified in this instruction
manual.
EMKO Elektronik warrants that the equipment delivered is free from defects in material and
workmanship. This warranty is provided for a period of two years. The warranty period starts
from the delivery date. This warranty is in force if duty and responsibilities which are determined
in warranty document and instruction manual performs by the customer completely.
Repairs should only be performed by trained and specialized personnel. Cut power to the
device before accessing internal parts.
Do not clean the case with hydrocarbon-based solvents (Petrol, Trichlorethylene etc.). Use of
these solvents can reduce the mechanical reliability of the device. Use a cloth dampened in
ethyl alcohol or water to clean the external plastic case.
1.3Installation
1.4Warranty
1.5Maintenance
1.6ManufacturerCompany
ManufacturerInformation:
Repairandmaintenanceserviceinformation:
EmkoElektronikSanayive Ticaret A.Þ.
DemirtaþOrganizeSanayiBölgesiKaranfilSk.No:616369BURSA/TURKEY
Phone:+902242611900
Fax:+902242611912
EmkoElektronikSanayive Ticaret A.Þ.
DemirtaþOrganizeSanayiBölgesiKaranfilSk.No:616369BURSA /TURKEY
Phone:+902242611900
Fax:+902242611912
DeviceType
Housing&Mounting
ProtectionClass
Weight
EnvironmentalRatings
Storage/OperatingTemperature
Storage/OperatingHumidity
Installation
OvervoltageCategory
PollutionDegree
OperatingConditions
SupplyVoltageandPower
TemperatureSensorInput
NTCinputtype
PTCinputtype
Thermocoupleinputtype
Thermoresistanceinputtype
Accuracy
ColdJunctionCompensation
SensorBreakProtection
SamplingCycle
ControlForm
RelayOutput
OptionalSSRDriveOutput
Display
LED
InternalBuzzer
: TemperatureController
:76mmx34.5mmx71mmplastichousingforpanel
Mounting.Panelcut-outis71x29mm.
:NEMA 4X(Ip65atfront,Ip20atrear).
: Approximately0.20Kg.
:Standard,indooratanaltitudeoflessthan2000meters
withnonecondensinghumidity.
:-40 Cto+80 C/-30 Cto+80 C
:90%max.(Nonecondensing)
:Fixedinstallation
:II.
:II,officeorworkplace,noneconductivepollution
:Continuous
:
:115
:24
:24
:10-30
:NTC,PTC, TC,RTD
:NTC(10k @25°C)
:PTC(1000 @25°C)
:J,K(IEC584.1)(ITS90)
:PT-100,PT-1000(IEC751)(ITS90)
:±1%offullscaleforthermoresistance
: Automatically±0.1°C/±1°C
:Upscale
:3samplespersecond
:ON/OFF
: A@250V forResistiveload( Output)
(Electricallife:100.000switchingatfullload)
:Maximum20mA,Maximum17V
:14mmRed4digitsLEDDisplay
:S(Green),P (Green), C(Yellow), F(Yellow),
CompressorOutput(Red),HeatingOutput(Red)
: 83dB
:
o o o o
o o
W
W
³
16(8) V
Approvals
230V ( %15)50/60Hz-1.5VA
V ( %15)50/60Hz-1.5VA
V ( %15)50/60Hz-1.5VA
V ( %15)50/60Hz-1.5VA
V 1.5WZ
Z
V
V
V
W
±
±
±
±
Compressor
7.Specifications
All order information of ESM-3710-N Temperature Controller are given on the table at above. User
may form appropriate device configuration from information and codes that at the table and convert it to
the ordering codes.Firstly, supply voltage then other specifications must be determined. Please fill the
order code blanks according to your needs.
Please contact us, if your needs are out of the standards.
V
Z
Vac,
Vdc
Vdc or Vac
can be applied
Þ
Þ
ÞW
c
8.OrderingInformation
Note-1:If input type is selected PTC or NTC (BC= 12, 18), Temperature sensor is given with the
device.For this reason, if input type is selected as PTC,sensor type (V = 0,1 or 2) or if input type is
selected as NTC, sensor type (V = 0,3 or 4) must be declared in ordering information.
ESM-3710-N
PowerSupply
Input
TemperatureSensor
Input
76mm/3inch
O
F
O
C
S
P
6mm/0.24inch
34,5mm/1.36inch
65mm/2.56inch
Maximum15mm/0.59inch
110mm/4.33inch(min)
71mm/2.79inch
29mm/1.14inch
50mm/1.97inch(min)
230V ( %15)50/60HzV ±
OptionalSupplyVoltage
-30V Z
115V ( %15)50/60Hz,
24V ( %15)50/60Hz,
24V ( %15)50/60Hz,
10
±
±
±
V
V
W
Standard
A BC D E FG HI /
/
U
V W Z/
/
0 1 0 0
1
RelayOutput(16(8) A@250V ,atresistiveLoad,1NO)V
CompressorOutput
E
SupplyVoltageA
InputType
BC
Scale(°C)
ESM-3710-N
4
-50°C/-58°F; 150°C/302°F
12
PTC(Not-1)
Temp.Sensorwhichisgivenwith ESM-3710-N
V
0
None
3
NTC-M5L20.K1.5(NTCSensor,thermoplasticmouldedwith1.5mcable
forcoolingapplication)
4
NTC-M6L50.K1.5(NTCSensor,stainlesssteelhousingwith1.5mcable
forcoolingapplication)
9
Customer
115V ( %15)50/60Hz-1.5VAV ±
5
230V ( %15)50/60Hz-1.5VAV ±
00 00
8
10-30V Z
-50°C/-58°F; 100°C/212°F
18
NTC(Not-1)
1
PTC-M6L40.K1.5(PTC AirProbe1.5mtSiliconCable)
2
PTCS-M6L30.K1.5.1/8”(PTCLiquidProbe1.5mtSiliconCable)
(77x35DINSizes)
YourTechnologyPartner
www.emkoelektronik.com.tr
Thankyouverymuchforyourpreferenceto
useEmkoElektronikproducts,pleasevisitour
webpagetodownloaddetailedusermanual.
9.Optional Accessories
RS-485CommunicationInterface
1.RS-485Module
2.PROKEY ProgrammingModule
Thedeviceisprogrammed(Uploador
Download)byusingtheparameters.
ü
ESM3710-N
SET
P
0°C/32°F; 800°C/1472°F
05
J,FeCuNiIEC584.1(ITS90)
0°C/32°F; 999°C/1830°F
10
K,NiCrNiIEC584.1(ITS90)
-50°C/-58°F; 400°C/752°F
11
PT 100,IEC751(ITS90)
-19.9°C/-4°F; 99.9°C/212°F
09
PT 100,IEC751(ITS90
-50°C/-58°F; 400°C/752°F
14
PT 1000,IEC751(ITS90)
-19.9°C/-4°F; 99.9°C/212°F
13
PT 1000,IEC751(ITS90
3
24V ( %15)50/60Hz-1.5VAV ±
NTC,PTC,
JorKTypeTC
2-WirePT-100
PT-10002-Wire
Output-1
ControlOutput
AlarmOutput
Output-1
Standard
Optional
(RelayOutput)
(SSRDriveOutput)
HeatingorCooling
Function
ON/OFFOperation
ControlOutput
AlarmOutput
2
SSRDriver Maximum20m,Maximum17VOutput( )Z
2
24V ( %15)50/60Hz-1.5VAW ±
,