Instructions

12
When SET button is pressed for 5
seconds, “P” led starts to blink. If
programming mode entering
password is different from 0,
programming mode entering screen
will be observed.
Main Operation Screen
Programming Screen
Change the value with increment
and decrement buttons.
Hysteresis Value for
Compressor Output
Press SET button for accessing to the parameter
value. Press increment button for accessing to the
next parameter, press decrement button for
accessing to the previous parameter.
Press OK button for saving the
parameter.
Press increment button for accessing to the
next parameter, press decrement button for
accessing to the previous parameter
Password Entering Screen
Programming Mode
Entering Screen
Press OK button for
accessing to the
password entering
screen.
Password Entering Screen
Enter programming mode accessing password
with increment and decrement buttons.
Note2: If programming mode accessing password is 0, only three parameters
are accessible, and the parameter values can be changed.
Press OK button for entering
the password.
Note1: If programming
mode accessing
password is 0,
Temperature Unit screen
is observed instead of
programming screen
Hysteresis Value for
Compressor Output
If no operation is performed in programming mode for 20 seconds, device turns to main
operation screen automatically..
i
Hysteresis Parameter for
Compressor Output
6.5 Entering To The Programming Mode, Changing and Saving Parameter
O
F
O
C
S
P
O
F
O
C
S
P
O
F
O
C
S
P
O
F
O
C
S
P
O
F
O
C
S
P
O
F
O
C
S
P
O
F
O
C
P
S
O
F
O
C
S
P
ü
ESM3710-N
SET
P
ü
ESM3710-N
SET
P
ü
ESM3710-N
SET
P
ü
ESM3710-N
SET
P
ü
ESM3710-N
SET
P
ü
ESM3710-N
SET
P
ü
ESM3710-N
SET
P
ü
ESM3710-N
SET
P