Instructions

14
All order information of ESM-3710-N Temperature Controller are given on the table at above. User may
form appropriate device configuration from information and codes that at the table and convert it to the
ordering codes.Firstly, supply voltage then other specifications must be determined. Please fill the order
code blanks according to your needs.
Please contact us, if your needs are out of the standards.
8.Ordering Information
Note-1:If input type is selected PTC or NTC (BC= 12, 18), Temperature sensor is given with the
device.For this reason, if input type is selected as PTC,sensor type (V = 0,1 or 2) or if input type is
selected as NTC, sensor type (V = 0,3 or 4) must be declared in ordering information.
A BC D E FG HI /
/
U
V W Z/
/
0 1 0 0
1
Relay Output (16(8) A@250 V V,at resistive Load, 1 NO,1NC )
Compressor Output
E
Supply VoltageA
Input Type
BC
Scale(°C)
ESM-3710-N
4
-50°C/-58°F ;
150°C/302°F
12
PTC (Not-1)
Temp. Sensor which is given with ESM-3710-N
V
0
None
3
NTC-M5L20.K1.5 (NTC Sensor, thermoplastic moulded with 1.5 m cable for cooling application)
4
NTC-M6L50.K1.5 ( NTC Sensor, stainless steel housing with 1.5 m cable for cooling application)
9
Customer
115V ( %15) 50/60Hz - 1.5VAV ±
5
230V ( %15) 50/60Hz - 1.5VAV ±
00 00
8
10 - 30 V Z
-50°C/-58°F ;
100°C/212°F
18
NTC (Not-1)
1
PTC-M6L40.K1.5 (PTC Air Probe 1.5 mt Silicon Cable)
2
PTCS-M6L30.K1.5.1/8” (PTC Liquid Probe 1.5 mt Silicon Cable)
(77x35 DIN Sizes)
0°C/32°F ;
800°C/1472°F
05
J ,Fe CuNi IEC584.1(ITS90)
0°C/32°F ;
999°C/1830°F
10
K ,NiCr Ni IEC584.1(ITS90)
-50°C/-58°F ;
400°C/752°F
11
PT 100, IEC751(ITS90)
-19.9°C/-4°F ;
99.9°C/212°F
09
PT 100, IEC751(ITS90
-50°C/-58°F ;
400°C/752°F
14
PT 1000, IEC751(ITS90)
-19.9°C/-4°F ;
99.9°C/212°F
13
PT 1000, IEC751(ITS90
3
24V ( %15) 50/60Hz - 1.5VAV ±
2
SSR Driver Output (Maximum 20m, Maximum 17VZ )
2
24VW ( %15) 50/60Hz - 1.5VA ±
3
Relay Output (30(15)A@240 V V,at resistive Load, 1 NO)
(Only valid for NTC Input Type devices)
Because of limited mechanical life of relay output contact, SSRoutput is recommended which
the device use PID control algoritm. The device with ON/OFF control algoritm, hysteresis
parameter must be set a suitable value for your system, to avoid too much relay switching.
Before commissioning the device, parameters must be set in accordance with desired use.
Incomplete or incorrect configuration can cause dangerous stiuations.
c
c