Manualshelf

Instructions

ManualsBrandsEmko ManualsAutomationBang-bang, P, PI, PD, PID Temperature controller Pt100, J, K, R, S, T -200 up to 17
21222324252627282930
4.1.5EMI-440Pt-100InputModule
4.1.4EMI-430TC(Thermocouple)or0...50mV InputModuleZ
23
SpecificationsofEMI-440Pt-100InputModule
Accuracy
PleaserefertoSection8.2.3or8.2.4forselectionofinputtypeandscale
Dimensions :
InputResistance :
14x30.7x41.4mm
Greaterthan10MW
: 0.5%
EMI-410, EMI-430, EMI-440 or EMI-450 analogue input modules can not be
plugged-in Module-1 and Module-2 socket at the same time.
EMI-410, EMI-430, EMI-440 or EMI-450 analogue input modules can not be
plugged-in Module-1 and Module-2 socket at the same time.
SpecificationsofEMI-430TCor0...50mV InputModule
PleaserefertoSection8.2.3or8.2.4forselectionofinputtypeandscaleofTCinput
type(L,J,K,R,S,T,B,E,N,C)
Z
Accuracy :
Dimensions :
InputResistance :
0.3%
14x30.7x41.4mm
Greaterthan10M W
Applications of EMI-430 0...50mV Input ModuleZ
It can be used to measure any process value and use it with an alarm function in applications that
2nd sensor input is necessary.
The voltage value (0...50mV ) on the module input can be used as process set value when
"remote set" function is activated and system can be controlled with analogue signal(0..50mV
) which is applied from remote point.
Z
Z
Detailed information about functions of EMI-430 TC or 0...50mV Input
Module are given in parameters section. For using these functions EMI-430 TC or
0...50mV Input Module must be installed to Module-1 or Module-2 socket.
Z
Z
EMI-430 TC or 0...50mV input module
8.2.3 or
8.2.4 for detailed information.( , parameters)
Z can be plugged in Module-1 or Module-2 socket to use
as 2nd sensor input, for measuring process value or for using alarm functions which are related to
measured value.
Also “remote set” function can be used by plugging this module. Please refer to Section
EMI-440 Pt-100 input module can be plugged in Module-1 or Module-2 socket to use as 2nd
sensor input, for measuring process value or for using alarm functions which are related to
measured value.
Also “remote set” function can be used by plugging this module. Please refer to Section 8.2.3 or
8.2.4 for detailed information.( , parameters)
i
i
i
i
For using EMI-430 TC or 0...50mV input module as 0...50mV , or
must be
Z Z